Gulfstream Hull Harness: Where Does it Come Out Up Front?

T

tboylan

Active Member
Joined
Nov 21, 2013
Messages
31
Reaction score
0
Points
0
Hi Guys,

I've got to snake a new transom mounted transducer wire to the electronics box. I can see the 'hull harness' tube on the starboard side behind the transom door.

My question is where does this tube come out up front? Is it behind where the capacity plaque is below where the throttle is mounted? I plan to tape the new transducer wire to the old and pull it through but want to know where the corners are and where the wire might get hung up.

Thanks!
 
A

artodea

Well-Known Member
Joined
Aug 24, 2014
Messages
87
Reaction score
3
Points
8
Location
Boston Northshore
Re: Gulfstream Hull Harness: Where Does it Come Out Up Front

On my '96 the two rigging tubes terminate under the helm and the best access is through the pry-out plate in the cabin (but the more recent hulls have a head there, right?). Once you get it in there you can run it up the chase to the helm.
 
E

ElyseM

GreatGrady Captain
Joined
Nov 18, 2007
Messages
933
Reaction score
45
Points
28
Location
highlands, nj
Re: Gulfstream Hull Harness: Where Does it Come Out Up Front

look in your manual. there are very good diagrams of many things, including rigging tubes. if you bought used, you should be able to download one from GW. good luck, ron
 
T

tboylan

Active Member
Joined
Nov 21, 2013
Messages
31
Reaction score
0
Points
0
Re: Gulfstream Hull Harness: Where Does it Come Out Up Front

Thanks guys!

I found the tube. I unscrewed the lower panel on the bulkhead next to the toilet.

Can't wait to snake the new cable through!
 
You must log in or register to reply here.