Recent content by g0tagrip

So I bit the bullet and ordered the new Evolution Helm chair from Pompanette for my 2007 Marlin. The base of the old one cracked and it will not tighten so it spins. I could not see a way to repair it. I had already repaired the plastic under the cushions a couple times. Actually fixed both helm...

Thanks for the info and pictures jcsurf!

What radar do you guys recommend for finding birds ? My two nephews are struggling with an old Simrad that is of no use.

My starboard F-250 did the same thing, there are three cam position sensors on the back of the engine. I replaced all three and no problems since.

I hung a dead seagull from the outrigger, that worked until my wife saw it.

I have Allstate. I bundled boat with the cars, been pretty happy with them so far.....knock on wood!

Ok, thanks. I will give them a try, but my experience with SEI is not good. When the coating stared to peel off I sent the unit back two them under the warranty, at great cost to me, and they did nothing and sent it back to me, without any repair to the paint.

Thanks for your recomendations!

Neither, the coating is a thick almost plastic and thick and hard.

A couple years ago we trashed my starboard engine lower unit, we hit something, anyway I bought a lower unit from SEI over in Tampa. after a couple trips the coating started to peel off. I sanded and painted but it just kept peeling off. Finally took it off and now I am going lot stripe all...

Try vinegar.

Skunk boat nailed it!

Thanks for posting the pictures Randy, Al

I have the same boat, 2007 Marlin, I put a floor hatch over the aft for access to the fuel water separators. I can send you pictures if you email me your address as I have yet to break the code on posting pictures here. My email address is: g0tagrip33@gmail.com Note the 0 is a zero not an ooo

I just squirt CRC 56 into it, and work the button until it frees up. I have had to do it once a year or so.