Search results

  1. H

    2002 192 Tournament Wiper Motor

    I just completed a complete rewire of my 2002 192 Tournament. In the process, I learned that the wiper motor is bad and need a replacement. I’ve tried searching but can’t find a thread specific to this model. Does anyone have a replacement part number? Many thanks.
  2. H

    2002 Tournament 192- Largest Fishfinder in box

    Just an FYI, I installed a Simrad Go9 XSE today in the driver glove box of my 192 Tournament. It is extremely tight, definitely the max that you could fit in the box. In fact it is so tight that you cannot put the cover on the unit when it is installed. I typically remove my electronics between...
  3. H

    2002 192 Tournament wiring

    I am working on rewiring a Tournament 192. Mine is a 2002. Does anyone have a source for the switches are breakers that were used? Also, does anyone know what type of connectors were used to terminate the panel harness? Many thanks.
  4. H

    192 Tournament wiring question

    I have undertaken running new wiring in my 2001 192 Tournament. The factory wiring is a mess. does anyone know whether there is a bus bar for grounding in the bilge? I can’t seem to locate one and all of the wiring in the bilge is a complete rats nest.
  5. H

    Sending Unit for Tournament 192

    I need to replace the fuel sending unit on my 2002 192 Tournament. I am going to go with a Wema sending unit. Has anyone replaced theirs on a 192 Tournament and if so, can you tell me the correct length or a part number? Many thanks.
  6. H

    Tournament 192 replacement windshield

    I got caught in a wind storm today and a flying tow tube ripped off my starboard windshield. Does anyone know offhand whether the freedom 192 windshield will fit a 2002 192 Tournament? I’m sure this will cost an arm and a leg and so alternatively, has anyone found anything after market that...
  7. H

    MFD on 192 Tournament

    I am looking to place a 7 inch MFD on my 2000 192 Tournament. Has anyone completed a similar install? Console space is limited on this model and I’m struggling to find the right spot. I wish it did not have the glove box or instead had a taller box/mounting surface in its place.
  8. H

    Bilge pump thruhull 2000 tournament

    Does anyone have a replacement part number for a the through hulls used on the early 2000s Tournaments? Mine are showing their age and I’d like to replace. Thanks!
  9. H

    Question about scuppers 2002 192 Tournament

    I was inspecting qthe Through hills for my scuppers today. They appear to be brass tubes. On the outside, there is a ring that screws into the transom, with a rubber flap. Was this typical of the 2002 era Tournament? The tubes appear to need replacing, and the flapper is dry rotted and will need...