Search results

Had a cutom panel built by VectorLED for my old Gulfstream. Looks cooler than the new boats and works well with the lettering backlit.

I have a cp-300 7" with an add on sounder box. The units work great, the sounder portion of the machine marks the bottom very well. The only complaint would be the mount, I did not surface mount the unit I used the mount that came with it. When touching the buttons the unit wants to move...

locked turbines I will be watching mine close, my fear is that they will fail again..

My flow meters locked up. The pinweel part of the rotometer in the fuel line locked up on both of my fuel meters, I contacted the service center for Northstar and they set replacements without questions. The replacements are working good.

Just replaced mine... I ordered them from Iboats.com less than $120 for both. I had to install two new snan screws on each, they changed the bottom flap that holds the bottom cusion in place. But the cusions fit purfect. If you havent removed the cusions yet make sure you lube the snaps before...

within a gallon I have run her three more times each time i have been with in a gallon on about approx. 50gal. on the total of the two gauges. They have been easy to use and understand very satisfied with the Northstars.

I ran the boat today and traveled almost 80 miles and boated my first NC stripper. The Northstar siad I used a total of 62 gallons, and I filled up with 58. Not to bad. That is aboout 6% but it is conservitive. I will run again before I calibrate.

I put a large door mat I got at Sam's in my skiff so my Lab's won't slip, that that may work. I going to try that in my Gulfstream next time I go out, if it works I will cut one to fit my cooler. I put a cooler in the back as well.

Here is the site I got mine from, I think they sell others as well. I almost baught the combo unit that had GPS, Fish finder & fuel. But I wanted the fuel data close to my engine tachs. I may upgrade later just to have a back up for every thing. Don't tell my wife.. www.boatersland.com

I recently replaced one of my trim motors, and I noted a different rate at the start of the problem then noted it stalling. I replaced the motor myself, I purchased a after market motor from the internet and it works fine now. The hard part was removing the broken bolts. I saved approx $500...

So far I would recommend the Northstar F210 I put her in the water today to test the flow meters and I am tickled. I ran down the water way and back noting the different flows at different speeds/RPM's, when I got back I totaled 11.2 and 10.9 = 22.3 gallons used. I filled her up with 21.9...

Recieved the scanners and installed, it took about three hours to install two. Have not tested in the water yet the wind blew like crazy yesterday. I did test on the water hose and noted that the gauge for one of my engines was more than twice than the other, turned out it was in leters, and...

Northstar 210 I ordered a pair for my Gulfstream, can't wait to install. They were about 200-300 cheaper than the Floscan. Will keep you posted on the intall and outcome..

Thanks for helping me with my list. Just fixed the broken bait/wash down valve, and a small weld repair on the top. The new battle is the bilge pump wiring. But I have had her out twice now and she is not afraid. Thanks for the suggestions, Please keep them coming. Thanks, Rob

I found this web site and could not believe the all the info on Grady's and how helpful everyone is, so I had to join in. I just purchased a '89 23s Gulfstream with twin '01 OX66 150's with dozens of little issues that I am planning on fixing. I am looking forward to learning all I can...