Recent content by LUNDINROOF

I tried TH Marine and got a “not currently available on line”. It looked like they did have the threaded end. I’ll call them tomorrow when they open. Thanks for both replies.

A well intentioned friend dropped my overflow tube in the gulf. Anybody know where I can find a replacement? I have ordered two and they are either too small or too short. Cannot find a threaded one either.

I'm trying to find where I can buy a Attwood 3 NM LED mast head light with the 24 inch pole. The Attwood manufacturer's number is 7824s1 and I get nothing when I Goggle it, E-bay doesn't have it and Amazon only carries the 12 inch model. I need 24 inches to clear the radar antenna. Anybody...

The unit from "Seadog" they call a door button is the closest thing I could find, with the appreciated help from DennisG1. I went ahead and ordered it, all the dimensions are close if not exact but the arm on the Seadog is plastic and my old one was metal. Typically, the freight ($5.97) was...

The one at Marine Part Depot is close, mine is a little over 2 inches in diameter and both pieces have two screw holes. It might work though, I need to check it when I get back to the boat. I might call Grady and see if they have an idea where I can find one. It would be better if I could find...

No, I couldn't find it in the Perko catalog either. The two base pieces form a circle, on piece is screwed to the hatch and the other to the top of the rear bulkhead. The arm attaches to the bulkhead piece and locks the hatch down. I can email a picture of the unit if you think it will help...

The latch on my fish box came apart and I cannot find a replacement. It is circular (two parts) with a pivoting arm that holds the box cover down. The bolt that holds the arm went missing and I cannot find a bolt/nut combination to fit it or a replacement unit. Have tried West Marine and a...

You get three guesses! Lundinroof.

Professional looking job.

I had the same boat, with the bracket and the kicker but with a 225 Mercury Optimax. The scuppers were "at" the water line depending on how much weight I put in the rear of the boat. If I remember, it sat in the water about like the pictures you posted. This is a great boat, plenty of room...

I searched the internet and found the best price at go2marine.com. I think that is the correct web site but if not someone on this forum will help me with the correct one. Someone on this forum also recommended them and since then I have ordered a few other items from them. They are easy to...

If I disconnect the three pairs of leads to the batteries and connect the charger to 110 Volts, shouldn't I get 12 votes between each pair? I get nothing on any of the lead pairs.

I too have had a lot of problems with this unit. I tried the rebuilding kit a couple of times and still had problems/leaks and finally purchased a new motor. Put the new motor in a couple of months ago and so far I have had no problems. Since you are not having leak problems, I doubt a...

The objects you are talking about are breakers that protect each circuit. These breakers gave me trouble the entire time I owned my last Grady. I don't think a year went by that I didn't have to pull the board and replace at least one. They are not a lot of trouble to change and if you are...

Thanks guys, I ordered one last night from Eastern Marine based on a little better price. I stayed with the 4 GPM pump because it was strong enough to do what I needed a wash down to do and it used less power and cost less money. I'm going to call them this morning and see when they plan to ship.