Recent content by Blaugrana

I put these ones in with no issue...Search Amazon though based on how many you need as you can get more for 3 bucks or so a cupholder

Mine has the same but it doesn’t do much for me to the point that I wear protective glasses when it’s dark out because of the wind. Use a cheap pair from Amazon. This boat was not designed for a 6ft person....when sitting the top metal piece on the window blocks my vision and when standing the...

Thanks for all of the advice. I’ll go with a different approach than I usually do when I tie the rigs and go with a wind-on leader.

Thanks.... So when I make the rigs, I typically put a swivel at the end instead of a loop. I’ve done this since a kid....Is that not a good practice and I should I switch to loops at the end of the rigs? I need to look into a wind-on leader more as I am not too familiar with it. The two...

Circling back to this thread for some more advice. Going to put the mono and braid on a new Penn Battle and Penn Squall 400 LP... Trying to figure out the leader. If I mainly use rigs that have about 24-36in of line, should I bother putting on a leader? I was thinking of having a leader that...

Bought these for my 2000 and just installed them. There was a thread on SS cup holders where some folks bought a different brand... Amarine Made 2pcs Stainless Steel Cup Drink Holder with Drain Marine Boat Rv Camper...

Thanks I thought it was Lowrance and couldn’t find it when I tried yesterday... Below Is the link. Anythingthat starts with EP is what you want. https://m.youtube.com/c/FurunoMarineElectronics/videos?disable_polymer=true&itct=CBQQ8JMBGAEiEwiZndHt7_vuAhVh9MEKHRgPAzY%3D

Agreed- I need to measure again as I know you said 1-7/8in and I thought my existing ones were 2in or so. Hoping I can find on Amazon to make returns easy if they don’t fit. None of the sites I saw those two products on had the OD.

Found some other options....The AMarine would fall under the China 316 but their dock cleats have gone over a year in saltwater and still look brand new. Some of us bought their cup holders https://www.anchorexpress.com/Sea-Dog-Stainless-Steel-Side-Mount-Rod-Holder--325150-1_p_83650.html...

Beautiful job, makes sense now knowing you did that as a custom job. Looks perfect Regarding the 316, how important is the 316 vs the other SS grades? Reason I ask is that I went nuts looking for 316 on a lot of the work I did this winter. When I removed the original scupper hoses on my 20...

Don’t think you will need to. My hole is on the bottom of the holder in the back. If you remove the highlighted fastener, you could reuse that hole. That’s what I have been thinking about doing but have not yet pulled the trigger. Going to try without first

I’m interested as well in the stainless...Curious where he got from Saw this on Amazon. The clip isn’t welded on so should be able to slide through if the diameter fits. Not sure what the fastener is at the bottom but I was thinking of popping that out and using the hole to fasten to the...

Take a look at those Lowrance videos where they compare their units to other unbranded MFDs....helps you learn about all of the features and how others perform.

How does the carpet hold up to stains? Does it just wash away?

Anybody try without the rod holders?? I’m debating on it and curious if there are any unforeseen issues. The two racks seem far enough apart to support the rods