Recent content by Cam Ena Sue

Currently my trim tab system works but the indication panel has been broken for some time. The switch, tabs and pump work - any possible solutions to just replacing the switch and indicator units. Does anyone know if the new integrated Bennett switches are compatible with the older pump/tab...

Figured out how to accommodate the new unit.

Appreciate the reply!

Have read a lot of discussions on this topic but have not seen any with my particular case. I am trying to decide repowering with a single yamaha 300hp versus the new yamaha 350hp. The boat currently has the motor it came with from the factory (Yamaha 250hp 2 stroke) - and I have always felt its...

Have not completed the install yet. Have had my hands full with doing the self bailing cockpit deck drains and thru hull scuppers...hoping to get the bait tank in this weekend. Will post pics of what I came up with.

West Marine did say the can order them - but its $175 a piece...Was hoping to find a better deal but might have to bite the bullet on this one.

I ordered those as well. I figured while I am hacking away I might as well do the complete setup. Now in the process of deciding where to cut the hole for the access to the starboard side...

See the below link for the Perko page with the thru hulls. Of course you cannot buy them there though.... https://www.perko.com/catalog/underwater_hardware/441/thru-hull_scupper_for_use_with_hose/

Since mine will be submerged quite often I am going with the safe bet of bronze (and if we bump the dock!) . See the below link for the Perko page with the thru hulls. Of course you cannot buy them there though...

I second this. I am currently going through this same process. I will be going with bronze since my boat is slip kept - but having a tough time sourcing them with a built in scupper. I know Perko makes them but cannot source them. Any help is appreciated.

Currently going through this process on my 1995 GW Islander. Wanted to get some input on what you guys went with for the new thru hulls. My boat will be kept in the water for 6 months of the year so I wanted to do bronze - I am having a tough time sourcing the 1.5" thru-hull with a built in...

A shelf would be an interesting idea. Give me a little more flexibility on where to route things...Thanks for the input.

Our rear Aux tank is only 27 gallons so there is a large gap (2.5') between the forward and rear tank. Unfortunately the poly oval tanks do not have the capacity needed for the West Coast fishery. The tank also fills through the whole water column and drains from the top but within the body of...

Hows it going - was curious if you would mind sharing how you plumbed up the on deck bait tank. Looking to install a similar one on my rig. Thanks, Sam

Attached are photos of the tank and the proposed location.