Recent content by DannyG

I have a 1995 Sailfish 27' that currently has twin 200's. I was thinking of repowering with 150's but not sure if this is a good idea. I don't really care about the top end and I know that these would have to work a little harder to reach the same cruising speeds, but if anyone has this set up I...

Thanks!

My 95' Sailfish had cabin rod racks which uses a rubber ring to hold the rods in the rack. Does anyone know the manufacturer of these racks and where I might be able to find replacement rings? The rings are approximately 2-1/2" in diameter and have a tab for grabbing and stretching into place...

Would you share the name of fiberglass shop you used? (Or send me a personal message if you prefer)

I fellow member on the forum mentioned that he had seen a post with pictures of a gas tank deck panel core replacement. I can't find it, can anyone point it out for me? Thanks.

I am also looking for these gaskets. I'm hoping someone here has an answer.

Again, thank you all for your help. BobP is correct - you must go to a store that services trucks. In the event anyone else searches the forum for the same information I found the replacement - ANCO Heavy Duty Wiper Blade - STK. No.52-20 It includes the metal blade and the rubber wiper. The...

Thanks all, looks like a visit to the neigborhood auto parts store is on the to-do list.

Thanks izzy, but this is not a standard auto type blade. It is wider than what you find on a car. The metal blade connects to the arm with a screw and nut, unlike the typical snap on blades found on cars. Someone at my marina said I would have to go through GW to replace it but I doubt that. It...

I'm looking to replace a 20" wiper blade for a 1995 Sailfish. I would actually just like to replace the rubber refill but it doesn't look like this can be done and that the entire blade will need to be replaced. Does anyone have a source other than a GW dealer?