DennisG01's latest activity
-
DDennisG01 replied to the thread Forward Bilge pump float question.See the part I wrote about the dash. That's how you can find the other ends of the wire - ohm them if you need to in order to confirm...
-
DDennisG01 replied to the thread Fender Locks.So "not" the Taylor Made ones? Which Taco locks are you referring to?
-
DDennisG01 replied to the thread Fender Locks.Tons out there - what style do you want? Post/link a few that you are thinking of and we can offer some thoughts. The Taylor made...
-
DDennisG01 replied to the thread 12v question.We use "X"Voltage to 12V stepdown converters all the time when rigging electric outboards on pontoons (they run 24V or 48V). So, sure...
-
DDennisG01 replied to the thread Scupper hoses.There's gotta be someone around with a trailer that you can borrow?
-
DDennisG01 replied to the thread Scupper hoses.I think you're fine to replace it in the water - just have a "worst case" back-up plan. For example, if your plug should fail... what...
-
DDennisG01 replied to the thread Forward Bilge pump float question."It clicks"... What clicks? Motor or float switch? Yes, you can short the float switch wires together to test wiring. Where does the...
-
DDennisG01 replied to the thread Fuel level measurement.Yes, standard ohms here in the States is 33 to 240 - that's been the standard for decades and hasn't changed. 33 for full and 240...
-
DDennisG01 replied to the thread 2000 Grady White 192 Tournament.Hmmmm... maybe I can put a piano hinge on the plexiglass.....
-
DDennisG01 replied to the thread 2000 Grady White 192 Tournament.If you figure it out, let me know. Been searching for 4 years for my mother's 2000 192. There are some salvage companies out there -...
-
DDennisG01 replied to the thread Gauge Identification.Yeah, it would be obvious as the cutout for the engine and dog box would be wider than normal hatches down the center of the boat. Oh...
-
DDennisG01 replied to the thread Gauge Identification.I'm not saying it is... but being on a bracket "could" mean it was originally a stern drive. But you know your boat better than me! :)...
-
DDennisG01 replied to the thread Gauge Identification.Take the vac hose off the gauge - does water come out? Take the vac hose off at both ends... does it old pressure or vacuum? Is the...
-
DDennisG01 replied to the thread Gauge Identification.So the OB is NOT on a bracket?
-
DDennisG01 replied to the thread Gauge Identification.Those gauges look a lot older than 2005 - are they original to boat? Did the boat originally have a stern drive? Does that small...