dogdoc's latest activity
-
dogdoc replied to the thread House Battery vs. Starboard battery.not sure about your engines but my old ox66 was a nightmare. unit was bolted to the block and cooled by salt water flow. needless to... -
dogdoc replied to the thread deck plate gelcoat color.Scrubbing with brush on right angle drill and acetone wash seems to have worked so far. Now thinking of restoring the helm chairs. I...
-
dogdoc replied to the thread deck plate gelcoat color.this is not a pie hole but a 2x4 foot deck plate
-
Got my hatch for the rear deck plate and installed it. Prior to install sprayed the plate with gelcoat. My color match is horrible...
-
dogdoc replied to the thread Thoughts on Shore Power Mods-265X.One of the first things I did on my boat was to pull all the non functional ac stuff. Cook top, microwave, fridge and the entire ac...
-
dogdoc replied to the thread bilge hatch.bought a 13x30 hatch
-
Pulling up my deck plates to reseal and inspect. The rear plate in this picture is over the bilge. Since I have owned the boat it has...
-
-
dogdoc replied to the thread ignition protection.These ACRs are voltage sensing relays and I would imagine have diodes? which prevent current from passing from the house bank. To me...
-
dogdoc replied to the thread ignition protection.i did and all but one wiring diagram shows si wire going to start lug on key switch. mine are sealed units and as i said cutting...
-
dogdoc replied to the thread ignition protection.batteries are are sized appropriate and good condition. wiring is new and good as well. devices are powered by house bank which other...
-
dogdoc replied to the thread ignition protection.i may be wrong but i also remember them saying cutting wire at the switch may void warranty?
-
dogdoc replied to the thread ignition protection.house and start are separated with exception of acr's. as you may be aware the df250 lacks the aux charge wire commonly found...
-
dogdoc replied to the thread injectadeck.my bad 9k saved!
-
dogdoc replied to the thread injectadeck.material for my full cockpit deck 500$, owner supplied labor. I would guess with miscellaneous cost well over 9000$
-
Anybody used this product to mitigate soft spots on deck. I just got a quote of 10k to repair cockpit deck with months of work time...
