Recent content by DonW

Sorry, 1997 Adventure 208.

Hoping to get lucky:), you never know...

Looking to buy a starboard rear seat cushion as it was lost. Picture shown is the port cushion. Maybe other model cushions will fit?

On a similar note, I can't find small tubes of contact cement for small jobs up here in MA, only half pint and above. Is it like a huffing thing? I get "carded" when I get the pint. I thought that went out in the 70's...

2 layers of Sea-Shox is a bit pricey for me, that's 400 bucks or so? https://www.amazon.com/SKYDEX-Sea-S...ce959475cf48c3ed944c5909ae1d52&language=en_US

OP here. We will see how this works. 4x4 foam fatigue mats cut roughly in half, bolted together, strips on bottom to drain and protect.

Thanks for all the replies. In the back of the garage i found a bunch of anti-fatigue mats that I am now cutting into a step and bolting together, roughly 4 inches thick or so. We will see how this goes before moving on to something more permanent!

Hi, '98 Adventure 208 owner here. While standing at the helm, I am too tall to see below the windshield, too short to see above, so my line of vision is the top of the windshield ( I'm 5'8"). I have stood on life jackets and seat cushions, but would like to find or make something that would be...

Hi All, The past few years have seen an increase in the number of gulls landing/eating/crapping on boats in the area (Buzzards Bay, MA.) I currently have a Bird B Gone gull sweep with a sand bag base that I put on my bimini top and bungee it. Looking to simplify the process. seeing if any...

Thanks for all the info, appreciate it as usual.

Hi, As seen in the picture I need new hinges for the glovebox/electronic box on my '97 Adventure 208. A search led me to these: https://shop.southco.com/en_us/c6-9 Any thoughts? Do they retrofit? Thanks, Don

You are so right, I will do that. Thanks!

Thanks for the info, actually did it both ways, thru the grommet, and cut the bottom open.While redoing I am going to put a bolt through the plastic backing to thru bolt it with one bolt to keep it in place like on my previous boat. Makes it much easier to remove.

Hi, Starting the process of cleaning up my '97 208. My starboard rear seat back needs reupholstering. It seems to be attached to the stern with screws which I can feel from underneath.The heads are under the cushioning. How do I remove the seat back? I am reluctant to pry it off, but seems...

I now run a 200 hp OX66. As I stated earlier, I don't really care about the going fast, I run WOT for about 30 seconds max, I just want the best performance. I would've expected to get over 40 mph WOT...