Recent content by GS White

Thanks for the offer 1st grady, but I already installed them using tuna mans method. Yes, and I'm in the middle of replacing the aluminum trim. I removed the old piece which was starting to become badly pitted. Then I epoxied the seam underneath the trim. Next up I'm going run a bead of 5200...

I like this all thread tool idea. I just have to be careful that its appying torque evenly. Why didn't I think of this? Thanks for the idea Tuna Man. On another note can I just use 5200 as i use this for all transom holes, seals, etc? Oh and I have plenty of west system to epoxy the holes...

I purchased new scupper tubes through a grady dealer was wondering if anyone has replaced these before? New tubes are flared on one side looks as if you need to install then flare the other side. Is there some special tool? I have a tube flare tool but that only goes up to 1/2 or 3/4. Thank...

Hello, been reading this forum since purchasing my grady last year. I have a 24' offshore. Anyway figured I'd sign up and start posting. I am in the middle of undergoing many projects with the boat and have lots of questions. Hopefully I can also contribute as I learn being a hardcore DIY'er...