Recent content by hooknot

The thru hull fitting on the starboard side,near the water line,which I think is for the fish box,the outside flange is worn off...It is a 1986 seafarer. How to get to it...?? Any Ideas??

1986 22ft seafarer i/o 4.3 fresh water cooled..How to add a fresh water flush to the raw water part.so it can be flushed out after every use,makes the risers and manifolds go a long way..?

Hi installing new elec on dash in a 1986 22ft seafarer.Can I get to the fuse panel from inside cabin??It has some panels covered in carpeting,but looks like you can scew them off..Will the wiring be accessable???

1986 22ft seafarer,can I get behind the instrument panel from inside the cabin to wire some stuff?? the inside wall is carpeted,if I remove the screws will i be able to get into the back of the panel???

I just purchased a 1986 22ft seafarer,Mercruiser inboard I/O...Trying to decide if it is a modified hull or a deep v??

I just got 86 seafarer inboard i/o,went to winterize the other day.took the outside plug out so the bilge could drain..looked in bilge,there is a stringer separating the front and it had a plug in it..I took the plug out,and a ton of water drained out of the stern..The front bilge pump may not...

Just got an 86 22ft seafarer.with a 2003 4.3 merc mpi,with an alpha drive,I was wondering what the fuel burn would be at cruise. Also what RPMS should I cruise at? and what should wide open rpms be,? and what kind of speed...I would think with that engine it should be good on fuel......AL