Recent content by igblack87

East Coast Fiberglass, Pembroke MA. Custom Fiberglass, Weymouth MA. Brewster Custom Boats, Brewster MA.

This story was great to follow along with. Nice pictures! Thanks for sharing.

Nice looking sled! Congrats.

I had my dealer replace the cap on a 2001 180 - that was $1200 and on my current 2006 222 - that was $1800 Seems a bit high, but then again, maybe they are estimating some repair or shooting high to deliver under budget? Ask them to go over the quote with you.

wow. what a wife to have!

Thanks, Bayside after Rockland :). We've chatted before!

I got them all out! Took the advice and soaked them for a couple of days...lots of "crud" on the bolts and washers. Going to get all new mounting hardware. Canvas is getting replaced as we speak (in Rockland).

Good tip, thank you!

Thank you all that commented on my question. Got all the screws out without snapping, breaking or stripping them! Soaked them in WD-40 over the past couple of days. When I go to put the antenna back on, going to use all new hardware and some good silicone.

Big Damariscotta fan, here!

Got 3 of the 4 acorn/regular nuts off. The last 2 are soaking in WD 40...I think I can get them. There is a grommet where the antenna wire goes through the T-Top and down into the electronics box - 3 small crews hold it in...that one will be interesting. I'm trying to soak it each day a...

DennisG01 - i'm taking your comment as a friendly jest :) BUT thats the point of this forum, ask questions, talk things through, is it not? I'll start with the wrench and phillips head on top with good downward pressure!

This is the underside of the vhf base. Going to soak it in PB Blaster...literally in a plastic bag.

You guys are the best! Thanks!

This is a follow up from my T-Top Canvas replacement thread. I need to get the antenna base and wire unscrewed before I bring it to the shop. I am concerned about the screws holding the base of the antenna to the T-Top frame being frozen in place. Should I continuously soak them with PB...