Recent content by Jtravis

Welcome to the club. I just had the transom done on my 2003 330 express this past week. Definitely disappointed with Grady's build quality.

The boat is a 2003. I'll definitely get some pictures of the process and post them for you guys. Thanks for the reply!

I have a 330 Express that needs a transom rebuild and I was looking for recommendations for fiberglass guys on Long Island's south shore. I was leaning towards South Shore Fiberglass but am open to suggestions. Thanks in advance!

Thank you very much for the reply, I will definitely look into the transducers you mention as well as the thread. Thanks again!

If you were in my place what would you do?

Thank you very much for the detailed reply! I don't think I can swing a 2k transducer at the moment but maybe in the future. I am new to the tile fish/swordfish game and I appreciate the advice!

Thank you very much for the reply! I will definitely look into the B265LH.

Recently I have been doing some Canyon fishing in the northeast. My Gt 51s don't reliability hold bottom in over 600 feet. I was thinking about adding a B175L for chunking tuna and for nighttime swordfish. I was hoping to get some opinions on this setup. The boat is a 330 Grady White Express...

Recently I have been doing some Canyon fishing in the northeast. My Gt 51s don't reliability hold bottom in over 600 feet. I was thinking about adding a B175L for chunking tuna and for nighttime swordfish. I was hoping to get some opinions on this setup. The boat is a 330 Grady White Express...

That is s sharp looking install. If you have the chance would you be able to give more info on how you did it? Thanks in advance!

My mechanic wasn't sure he would be able to reach the thru hull fittings if he went through the side wall. I bet the hole for that shower unit is much larger than the inspection hole he cut so it might work.

My boat is an '03 and my shower is under a seat on the port side. If my shower was in the transom this would make for a pretty awesome upgrade!

Thanks for taking the time to post a pic. My mechanic cut the holes based on the images you guys shared. I definitely appreciate it!

Thanks for the ideas! I think the first two options are my best choices at this point.

Thank you very much for taking the time to post a picture. I will definitely show it to him. Hopefully he will be able to reach the thru hulls from there. Thanks again!