lazy grady's latest activity
-
4/8/24 Relative to my 1992 GW Explorer Walk Around 24', thinking I might reduce bow rails to say 4" to 6 " in height? My thinking is... -
lazy grady replied to the thread Bow mount trolling motor on a fisherman 180.Never fished for an entire day, Old Dude! Use it in the Pamlico Sound and near shore in ocean. With 3' plus waves, I would question...
-
lazy grady replied to the thread Bow mount trolling motor on a fisherman 180.I have upfitted a 24' GW Explorer with a trolling motor. Enclosed are pictures. Sent from my iPhone
-
-
lazy grady replied to the thread power trim and tilt.pt&t switch at motor NOT helm has not worked for several months. I use the helm switch. The pt&t switch at the motor is and has been...
-
lazy grady replied to the thread power trim and tilt.Pt&t has not been working for several months. Mechanic recommended not to replace, to costly given labor to remove. He left it...
-
lazy grady replied to the thread power trim and tilt.2/28/24 took cowl off. Pt&t switch unhooked. Question: could moisture still be the problem? Note 2 switch ends were laying in the...
-
lazy grady replied to the thread power trim and tilt.Great. I will try it today.
-
lazy grady replied to the thread power trim and tilt.2/27/24 Thanks a bunch. It appears I need to disconnect the pt&t switch that is on the starboard side of the motor? If this is the...
-
lazy grady replied to the thread power trim and tilt.2/25/24 Thanks to all! My mechanical skills are limited. Locating the various wires, relays, trim motor and cowl/throttle switches...
-
lazy grady replied to the thread power trim and tilt.sounds right. my switch at the motor does not work. where is the switch at the helm, in the throttle handle? Do I just remove the...
-
lazy grady replied to the thread power trim and tilt.2009 Yamaha F-250 with say 700 hours. Serviced annually. Thinking of greasing the rods on motor as well as putting electronic...
-
2/22/24 Went to boat. Cut battery switch on. When I hit PT&T switch to lower motor, motor would not go down even though PT&T motor was...
