Recent content by MLC

The boat shaped brown thing is the top of the transducer fairing block. The platform it is on is per Grady for the bilge pump and switch. At this location the fairing block can be cut flush and shaped with a 5" orbital sander to match the bottom contour. The flush cut was perfect for the top...

Here you go. If you go this route, let me know and I'll share what I learned.

I'll take one of the inside installation and send later, unless my dock is still covered in snow.

I installed a B275LHW center keel where my forward bilge pump is located in my 330. I installed epoxy blocks on each side to accommodate the new locations for the bilge pump and switch. Both pump and switch had plenty of extra wire and room for the move. I also installed a TM 3 in 1 a couple...

I have a 2005 330 with 2 - 12 inch evo 3s. I installed a b275 l-hw centerline under the mid berth where the forward bilge was located. I moved the bilge pump and float forward on each side of center on 2 small epoxy pads I made. I also installed a tm 3 in 1 just a couple inches off center to...

I just replaced the one on my 2005 330. I used a 24" Roku smart tv and a Wali 15" extendable mount. I also replaced the inverter as it was corroded significantly. I used a Bestek 500w pure sine unit. It's located behind the fridge. I probably spent $250 total and it looks and works great.

I too have a 265 that I’d like to repower. What is your most economical cruise speed and gph with the DF 200’s?