ROBERTH's latest activity
-
ROBERTH replied to the thread 265x with a bow mount trolling motor?.I would not remove the pulpit as you will likely need some fiberglass work. Why remove it when others have found solutions to mount the... -
ROBERTH replied to the thread Trailering.Yeah, we could go back and forth all day....lol. :) I want a diesel also. Would love to have one, but they are not always practical for...
-
ROBERTH replied to the thread Trailering.More quarts of oil and frequent fuel filter changes as well as DEF fluid, etc. They cost more than gas.
-
ROBERTH replied to the thread Trailering.I personally would hesitate to use a 1/2 ton truck to pull that boat. Even though they have those high tow ratings, most of them have...
-
ROBERTH replied to the thread 90" Garmin Kraken on 228.Thanks for the pic.
-
ROBERTH replied to the thread 90" Garmin Kraken on 228.I found some options on Amazon for a Li Time battery and charger combo that would be a 36v 100ah battery for a reasonable price. I found...
-
ROBERTH replied to the thread 90" Garmin Kraken on 228.Thanks for the links, looks good. I assume those are 1" rails on the Grady's.
-
ROBERTH replied to the thread 89 25.5 Sailfish repower weight question.For the HPDI's the 200's are awesome in how they start/run and do very well on fuel. However, there is a lot of reading in how to keep...
-
ROBERTH replied to the thread 90" Garmin Kraken on 228.Hard to tell in the pics, but does the prop on the TM get in the way of an anchor or pulpit? Also, any info about source and parts used...
-
ROBERTH replied to the thread Water in Sailfish.My experiences over time with the same issue: 1. Rub rail not sealed allowing spray to run into the liner and down to the bilge. Had to...
-
ROBERTH replied to the thread 89 25.5 Sailfish repower weight question.The older 200hp Yamaha Carbureted motors weigh about 400lbs. The OX66 250's about 525lbs according to Google. Can that hull handle the...
-
ROBERTH replied to the thread Seakeeper Ride on Grady 235.I think in my case with the 252G, it rides exceptionally well with normal hydraulic tabs. I start my trip heading for the inlet and set...
-
ROBERTH replied to the thread HPDI 200 - how smooth should it run at low RPM?.Seems that Pennzoil no longer makes the full synthetic as I could not find any reference to it anywhere. I used to use their semi...
-
ROBERTH replied to the thread HPDI 200 - how smooth should it run at low RPM?.Ok, I went back to Project Farm and also some other references. I feel like I have been reschooled. Pretty sure I have watched these...
-
ROBERTH replied to the thread HPDI 200 - how smooth should it run at low RPM?.Hi Dennis, yeah, I had mentioned I was switching over to the Techron Marine, but it is still sitting on the shelf since I have not run...