Recent content by RockLobsterBOS

Grady White had a design flaw in the early 2000's with the rear vents on both the port and starboard side. This is a known issue with GW esp. 2002 - 2008 30 and 33 Express Cruisers. The repair was done professionally prior to me purchasing the boat by a very reputable fiberglass company that...

Looking to sell my 2004 Grady White 33 express cruiser probably one of the dryer boats in the area of Buzzards Bay. In 2023 the port side core replacement was done from midships to stern. Engines removed transom grounded down epoxy and recapped both done by East Coast fiberglass in Pembroke. At...

we will try it. However, when under tension and without a fishplate I would think the motor cover sides would be the next touch point. Test it tomorrow as we will have calm seas here in Buzzards Bay and a good day to give it a go

I understand towing position, and motor on/off based on preference. What I do not understand is when I try to tow from my rear cleats on my 33 Express the towing bridle goes directly over the outboard's engine covers. This results in the line coming in contact with the covers and would cause...

Hi I have a 33' 2004 GW express and need to replace the microwave. I have a MW640WA Samsung in there now looks original. I have looked for .6cuft microwaves with the same dimensions. No luck Has anyone replaced theirs and if so with what? If your interested the microwave does not allow keypad...

Hi If I read my documents right the 2004 33' GW express has a deadrise of 20 degrees. I need to replace my transducer on a pair of Garmin 12x3 xvs units. I am looking for the best transducer I can get for under a thousand that gives me water temp , fish id and of course bottom accuracy for...

Do you by any chance remember the model you purchased?

My Garmin believes it is a 12 pin transducer. It does not show a brand, hence why I am asking in this thread. Thanks for the reply

Hello looking for some data. 1. Does anyone know where you can purchase the sink top that is made from Corian to match the counter tops? If not original after market? GW does not have them 2. Has anyone replaced the fresh water tank sensor? If so, where did you purchase the sensor? 3. This GW...

I have a 2004 33 Express. Not only did the transom show signs of wet areas so did the starboard side starting at the vent aft. This also is normal for the Express 2004 though 2009 I am told. The starboard side was completely redone up to midships, prior to me purchasing the boat. The glass shop...

Hello My 2004 33' Grady White Express needs new navigation lights. The STDB light appears to have a broken socket. I want to replace them with ATTWOOD LEDs and wondering if anyone has done this. The original are Attwood but are no longer available. I am told that the Attwood LIGHTARMOR 2NM LED...

I bought the system that connects to teh bleeders on the pistons and then allows air to go back into the bottle. not sure I did a good job but I did not see bubbles after I did it i teh clear lines provided with the kit

I found that I needed to add hydraulic fluid. Once I did this it was better not great but better. I have a question for the forum. This boat does not track well at all. We have been putting some hours on her over the last few weeks and when underway I look like I am in submarine avoidance. My...

I do have two. Do you remember the model of teh SeaStars that you have?

Did you do the install yourself? This is not a cheap upgrade form what I hear. 3K for the pump plus need to add time and materials. Also let me ask this. Was the pump installed near the holding tank? GW told me they get installed in the mid berth panel where the holding tank is.