Recent content by Scottwd1

  1. S

    What's the best caulk to use for mounting a new transducer on a Grady

    use 5200 or 4200 "caulk" is typically not used for below the waterline.
  2. S

    Outrigger Bases Wanted

    Thanks bud I reached out. Much appreciated
  3. S

    Outrigger Bases Wanted

    thanks so much for the reply back. Yes those are the ones. I will check your recommendations Ebay didn't have. Thanks again much appreciated.
  4. S

    Outrigger Bases Wanted

    Thanks so much for the reply. Technically these are referred to as side mount. I'm not sure if they will work on the hardtop properly without that extra latch mechanism that's shown in my photo posted? As much as i tried to find the direct replacement no dice. My though is they are NLA and...
  5. S

    Outrigger Bases Wanted

    Hi All I'm looking for a pair of the outrigger bases shown in the photo. Used is ok if in great condition. Ideally looking for new, does anyone know who makes the one shown in photo. Thanks in advance everybody.
  6. S

    Composit Teak Decking Inquiry & Props to GW Performance Welding.....

    Hi happy new year. I am looking into Dekit and will keep all posted with finished product if I decide to use that company.
  7. S

    Dekit Non Skid GW 232

    Happy New Year All. New year new projects to start thinking about. Has anyone in the NY area used Dekit for their cockpit and swim platform areas. I was given a quote and a Rep from Dekit, whose name is Steve. I would love any feedback and photos of their work specifically on a Grady...
  8. S

    Composit Teak Decking Inquiry & Props to GW Performance Welding.....

    Hi all. Does anybody have a 232 with Fo-Teak installed (cockpit & Bracket platform) they are proud off? I'd love to see some ideas/pics. Gonna put it on the winter to do list. Also where did you purchase from? We a have local supplier on LI, but very pricey. Thank you in advance : )...
  9. S

    Wanted: OEM Hardtop Rod Holders/Rocket Launcher for Gulfstream.

    Thank you for the reply. decided to have one made with 6 rod holders. My old grady only had 4 rod holders, so this will be a nice addition.
  10. S

    OX66 225 over heats

    I'm coming in on this a little late here but. Was the motor overheating prior to you replacing the impeller? In your case you probably did not seat everything together correctly under the impeller housing causing poor flow until you goose up the throttle a bit. Often times a slow overheat at...
  11. S

    Wanted: OEM Hardtop Rod Holders/Rocket Launcher for Gulfstream.

    Trying to locate an original Factory Rocket Launcher for above mentioned model. I have found a few companies that will make but love to keep it original. Whacha got Grady Folks Thank You