Recent content by Scottywotty

Thanks luckydude, Yeah, I thought about that too, I just don't know a good place to start. I was hoping to get there w/o too much research. Still looking...

I would really appreciate any follow up as this is something I'd like to do to our 208 as well. Original seats are not comfortable, we spend most of the trips standing. Thank you,

I've used MarineTex on mine, I added a little brown pigment to get closer to the Grady White, white which is almost a Navaho or swiss coffee white. sand down after buff and wax. Really pretty easy.

Hi Guys, I thought that subject might get your attention! I'd like to swap out the original seats in my 1996 Adventure 20 for something a bit more comfortable especially for the longer trips to the islands. Wondering what others have done in this regard? also looking to purchase them used or new...

Hi Gang, I need to do a bunch if touch ups( filled screw holes, worn down areas etc) on our gel coat, does anyone know what this color is? and possibly where I can pick up some for touch ups? Thank you!

I have the same exact question! except my boat is a 1996 208 Adventure, I am installing some Bose 131's NOS Grateful for any replies!

Thanks Guys! any pros/cons on stainless over aluminum? All the yammy's in the harbor where we stay seem to all have SS

Hello, my Partner and I just re-powered our new to us 208, wondering which prop will work best in this circumstance. we put an aluminum pilot house on this boat( designed and built by us) which is why we decided to bite the bullet and re-power to brand new. The old 2-stroke was perfect except...

Hi Guys, we just put a new(2025) yamaha F200 on our(1996) Grady 208, any suggestions on the best prop? we are using the one that came off the old yamaha 200 2-stroke. Appreciate all advise.

My partner and I decided to go to a local community collage and learn how to TIG weld aluminum so that we could build a badly needed hard top pilot house for our 1996 20' adventurer I think it came out great! though we are still in the outfitting stages of relocating everything to the top It...

I would like to resurrect this thread, we replaced all of the thruhulls w/ stainless, however getting to all of the clamps, elbows, and hoses to get good tight connections is impossible. I was just wondering what anyone else may have done that we haven't thought of? This is a real issue for a...

Hi Guys, We just bought a 1996 208, we wanted to keep it in the water but after a week noticed the bilge pump running every 20 minutes or so. luckily we still have the trailer and were able to pull it out of the water and start working on replacing all the plastic T-Hullls. what a job! I think...