seasick's latest activity

  • S
    seasick replied to the thread Scupper hoses.
    Key question is whether the scuppers are under the water or above the water line.
  • S
    seasick replied to the thread Scupper hoses.
    If the hose were to break, would water flood the bilge? Probably not since the scuppers rely on gravity and a downward slope to drain...
  • S
    seasick replied to the thread Bow eye hook crack.
    I stand semi-corrected:) Does that Sea Ray fact apply to all hull sizes? At my club, there are limited examples of SeaRays and those...
  • S
    seasick replied to the thread Bottom paint.
    Depending on what primer was or wasn't used on the bracket, the copper based antifouling may not be an issue. If the bracket was not...
  • S
    seasick replied to the thread Bow eye hook crack.
    That area was fixed before and apparently not correctly. First step is to inspect the inside of the anchor locker. Is there structural...
  • S
    seasick replied to the thread Low Idle speed question.
    You can't assume that both engines had the problem at the same time since it is possible that the previous owner had the problem at...
  • S
    seasick replied to the thread Leaving the group.
    I sold my Grady a while back and bought a non Grady boat. I asked about the forums position anf if I should leave it. I got a lot of...
  • S
    seasick replied to the thread Replacement of small pin.
    On the boats I have owned, the rotating ( swiveling ?) is controlled by a knob you turn to loch the seat to the pedestal. The spring...
  • S
    Yamaha does not put manufacture dates on engines anymore and hasn't for quite some time. Certified dealers do have access to date by...
  • S
    seasick replied to the thread Looking for some advice on lift.
    1 by 5 doesn't sound right to me. The 4 x 6 is probably better assuming the 4 inch edge is what the hull rests on. Depending on how the...
  • S
    could be a lot of things but my first thought is a bad rod, piston/bearing. Try running with one plug wire disconnected and see if the...
  • S
    seasick replied to the thread Water filter for 330 Express.
    Good to know that it has held up.
  • S
    seasick replied to the thread Water filter for 330 Express.
    Do you operate in a salt water environment? I was wondering how well the hardware holds up in salt air. Is your shower water filtered?
  • S
    seasick replied to the thread Water filter for 330 Express.
    My first reaction was that If you want to drink or brush your teeth with boat water, I would rethink that idea. General washing can be...
  • S
    seasick replied to the thread Help Identify this switch.
    I agree with Dennis. Looks like a kill switch ( a Mercury type at that )