SkunkBoat's latest activity

  • SkunkBoat
    SkunkBoat replied to the thread 12v or 24 system.
    what do you mean by "the batteries are 24V"?
  • SkunkBoat
    SkunkBoat replied to the thread Label Maker.
    get new switch covers
  • SkunkBoat
    SkunkBoat replied to the thread New Batteries.
    Forget the meter.
  • SkunkBoat
    SkunkBoat reacted to DennisG01's post in the thread New Batteries with Like Like.
    Also, closely inspect the connections - really close. A multimeter is good, but it doesn't tell you if enough amperage is flowing...
  • SkunkBoat
    SkunkBoat replied to the thread Thru Hull ID.
    It looks like you have an Airmar B744V "triducer". It has a paddle wheel for speed? They require a 2" hole. The direct replacements...
  • SkunkBoat
    SkunkBoat replied to the thread New Batteries.
    Check the connection of the "motor to battery" or "Starter" cable. The Neg will be connected to a battery and the Pos will be on the...
  • SkunkBoat
    SkunkBoat replied to the thread Grady White Chase 263 transducer mounting.
    Hard to tell with the paint ..It looks like you have an Airmar B744V "triducer". It has a paddle wheel for speed? Its mounted on flat...
  • SkunkBoat
    SkunkBoat replied to the thread ignition protection.
    It has electronics that control a RELAY that Combines (makes parallel) the batteries when there is a charging source(running motor). It...
  • SkunkBoat
    SkunkBoat replied to the thread ignition protection.
    idk what the mechanicalal key/start is like. On my fly by wire, the KEY does not have a start position, just an ON position. There are...
  • SkunkBoat
    SkunkBoat replied to the thread 265 Express Dash suggestions.
    Exactly!
  • SkunkBoat
    SkunkBoat replied to the thread ignition protection.
    Go on blue seas site and look at the diagram and instructions
  • SkunkBoat
    SkunkBoat replied to the thread 265 Express Dash suggestions.
    I pondered doing something with the bubble and after a half assed assesment determined it was more trouble than its worth. I'm pretty...
  • SkunkBoat
    SkunkBoat replied to the thread ignition protection.
    If the house is separate from starting batteries, then starting motor cannot effect the House 12v. Separate your 12V House from the...
  • SkunkBoat
    SkunkBoat replied to the thread Transom thru hole.
    Sometimes they stay open a little until water pressure closes them but they should not be pushed out by the tube
  • SkunkBoat
    SkunkBoat replied to the thread Transom thru hole.
    Cut the old flap off and use as a gasket to extend it out. Thats what I did
Show older items