SkunkBoat's latest activity
-
SkunkBoat replied to the thread raymarine suzuki communication.that is a Device drop cable. You may need one of those for your garmin. You will need to go from the zuke backbone to n2k backbone so... -
-
SkunkBoat replied to the thread raymarine suzuki communication.Oh uhg so Raymarine uses its own different plug design for n2k. That sucks... Its my understanding that they use N2k standard but...
-
SkunkBoat replied to the thread Refrigerator....If your boat is at a nice marina with a pool and patio tables and you use it as a weekend getaway "camper", then a fridge makes sense...
-
SkunkBoat replied to the thread raymarine suzuki communication.what will you get on Axiom that you don't already get on 9" garmin and 9" Raymarine? You can connect zuke to N2k but you need an N2k...
-
-
SkunkBoat replied to the thread Automatic Trim Tab Controls.So I can't find the threads were we lamented 265 express trim tabs. Must have been someone elses thread. I would have tagged it 265...
-
SkunkBoat replied to the thread Automatic Trim Tab Controls.265s have special short actuators. The sensor in the new kit won't work on the existing pistons. the shaft is short. I looked into it...
-
SkunkBoat replied to the thread Bilge pump wiring woes.Ok if we’re going to figure out what is specific to your boat, we need more information. Which one of those crusty green switches in...
-
Well, I finally got around to this project on the 2005 270. I thought I'd include a couple details that might avoid a headache: If you...
-
SkunkBoat replied to the thread Grady Marlin Livewell gas shock.Taylor and Ameritool
-
SkunkBoat replied to the thread Bilge pump wiring woes.Yeh....Thats obvious.... But you don't need a switch position for auto
-
SkunkBoat replied to the thread Polishing fuel.I agree I would not burn bad gas in my car. He said the boat ran fine. I'm going under the assumption that the gas is usable. It has...
-
SkunkBoat replied to the thread Bilge pump wiring woes.Was the original switch an Auto/manual? My Grady and many others only had a Manual switch. The "auto" float switch was fed from a...
-
SkunkBoat replied to the thread Polishing fuel.Maybe you can get someone to take the gas?
-
SkunkBoat replied to the thread Light Cut Suggestions.3M Finesse It 2 works pretty good for what you describe. Then needs wax... Oh....not done by hand.... forget my recommendation...I...
-
SkunkBoat replied to the thread Polishing fuel.If you have ~200 gals of 1 year old (or older?) gas you are better off removing it and burning it in cars & lawn mowers(assuming it is...
