tech_dog's latest activity
-
tech_dog replied to the thread flat bolts used to connect hinge to plexiglass.I may have found them... -
-
tech_dog replied to the thread Sending Unit for Tournament 192.It was a little hard to find here in the US too. I ended up buying it on eBay for $44 + $10 shipping...
-
tech_dog reacted to seasick's post in the thread Carburetor rebuild - Pilot screw turns question with
Like.
The screw you are referring adjust the amount of fuel at idle. The throttle plate on the other hand adjust the amount of air. If you... -
tech_dog replied to the thread Carburetor rebuild - Pilot screw turns question.I'll reinstall the carbs this weekend, and my starting point will be the 1-3/8 spec. I did carb rebuilds, with kits, so everything is...
-
I'm rebuilding my 1995 Yamaha V6 2 stroke carbs and have been verifying the Pilot Screw turns from all in before i remove them. Each...
-
tech_dog reacted to Halfhitch's post in the thread Grady White off white Spectrum patch paste # 553802K with Like.
Trapper, I just saw this thread. Don't know how I missed it when it was current. Spectrum color is right here in Florida where I live...
-
tech_dog replied to the thread flat bolts used to connect hinge to plexiglass.I searched high and low for an exact match and never found them. I contacted Grady White Customer Service to see if they could help...
-
Oh yes, there are people like that.
-
tech_dog replied to the thread Sending Unit for Tournament 192.I've had 8" and 9" senders in my 96 192, and I think the 9" gives better information. I did a fill test and the 9" sender was still...
-
tech_dog posted the thread Name/Find this part - Corner guards under back to back lounge in General Discussion.I'm redoing my Tournament 192's back to back lounge seats and I'm looking to replace the nylon corner guards that go around and under...
-
-
tech_dog replied to the thread Tournament 192 replacement cutting board.If you put a 3/8" radius on what was the top sides, you could flip it over. You'd have a new gap at the edges where it meets the boat...
-
tech_dog replied to the thread Tournament 192 replacement cutting board.Nope. I was going to do that, but the bottom side needs the 3/8" radius so it can sit flat on the support. Upside down doesn't work...
-
tech_dog replied to the thread Tournament 192 replacement cutting board.It was $270. If that's even close for you, you might be able to get a lower price by asking them to re-use the CAD/CAM they created for...
-
tech_dog replied to the thread Steering Wheel Cap.My guess is a Schmitt Model 170 Destroyer 13 1/2"
-
