Recent content by TheRooster

Inside

Install is complete B175 H-W. Wasn’t to bad just a little tight. Sealed with 4200 hope to try it out this weekend !

Just spoke with Grady. Was told the hull isn’t cored in this location, and it should only be roughly 3/4 inch thick all glass.

Yes it is, I’m hoping I get lucky and have a few 283 guys chime in on where they drilled threw!

Yes the first pic has the old B45 in the factory threw hull cavity. That will be behind the new Airmar I’m mounting about 8” on Center. To the right of the electrical tape if looking down in the bidge. It’s hard to see on the 2nd exterior photo it’s hidden by my hand. It just looks as tho the...

Good afternoon all, I’m Looking to install a Airmar B 175Hw 20° tilt in my 2005 283 release. I’m wondering the best location to do so. After a bunch of measurements and research I’m hopping to install it right in front of the starboard side factory transducer pocket. My only question is the hull...

Thank you ! I will try and reach out. As of now I can’t find a 285 Hw any where they are all back ordered. Such a bummer!

I believe this is what I’m looking for after talking to Airmar. Now I need make sure that it has the correct end for my simrad.

Good afternoon all, I will be purchasing a 12”NSS EVO 3 to install on my boat. I’m looking to update the transducer at the same time. My existing ducer is a stem style threw hull transducer. I was heavily leaning towards running a airmar 175 HW but I would rather not cut another hole in the hull...

Is anyone running twin F225’s on a 03/2004 257 advance. I understand that the transom is only rated for max 350hp. I would like to know if anyone is running anything larger than 150s. Are the scuppers under water? Thanks