Recent content by ThruTraffic

Luckily I have a steel building with a 20 foot ceiling. I've hung a two ton chain hoist from a beam and unloaded a 2300 lb power hammer before so I think that 115 won't be a problem. Visuals always beat speculation.

Cool. Thanks! I'll get back in there and look with a new perspective. I didn't think about shapes as a delineator.

Wood isn't visible inside or out. Would have to lift the engine to remove the aluminum cap to actually see wood. No flex pushing the motor up and down. No voids exposed by hammer test. I don't know for certain its bad but given it's age and reports on those era boats having problems I figured...

Where is the wood in the transom of a 1994 Spirit 175? I'm thinking of tackling a transom repair and would like to do a pour. If the wood extends from gunnel to gunnel then a pour may not be an option. I'd have to remove the entire rear end of the boat to replace the wood if pour isn't an...

Thanks. Used search before posting. None of my (and your) hits were all that helpful.

Pic is of the back and seat cushions I’m looking for. My frame is the same. I’m not getting much of a response from vendors and some want more to make them than I can buy something new that isn’t exact but would work. Some new frames with new cushions are cheaper than custom cushions alone...

That's it. I'm out. Unbelievable.

Where does it say in my post I was asking for help??? I AM happy there are many folks that are willing to help "when I ask for it". :) I'm asking a simple question. I'm not looking for a trim tab discussion. I've read enough trim tab threads on here and Hull Truth to make my head spin. Once...

Are there any Spirit owners out there who have and can share their experience with SLT10s on their hull?

Are there any Spirit owners out there who have and can share their experience with SLT10s on their hull?

Yes........, I know the ladder strut will have to be moved.

I'm looking for information from people who have installed Bennett SLT10s on their Spirit 175 (or anyone that has the same type of transom shape). I've spoken to Bennett about this. Can't find customer service like that almost anywhere these days. Kudos to Thomas. It looks like there is only...

The rigging pipe from the starboard access port to the console does exist. It terminates at the right rear corner of the console. I found using a fish to pull a large cable (2x#6awg) to be problematic as the fish/wire junction kept hanging on something in the pipe. I dumped some dishwashing soap...

Thanks for all the responses folks.

I was an electrician for 15 years. Pretty sure I'm fairly adept with a fish tape. I need to know the location of the end of the forward rigging tube on the console end. In the wiring diagram it is shown as just ending and the bow light wiring just magically jumps over to the console.