Recent content by TonyUSMC

I cut the end of the bolt off and used a 1/8th inch thick cutting wheel on an air powered cutting tool and used some tri-flow lube and a large flat head screw driver to back it out. then again the bolts i was backing out wernt too far gone; they had some strength left.

i just reattached a dive ladder on my Dolphin. The previous owner cut a square hole in the back of the seat (in the glass) so he could access the bolts. I made new seats the put stainless hinges on the back they can be swung up incase i had to get back there again. my point is, you might have to...

decal removal I used a paint scraper an iron that will steam when it is vertical. i did that as well as using a wet rag as a buffer (steam and heat shot right through) between the iron and the hull. I just replaced the GW logo graphics on my '78 Dolphin. It worked nicely even though the...