Recent content by ttles714

My 2007 Marlin 300 has 25'' shaft twin 250's.... when I make a steep turn, she cavitates on the opposite side , even with the motors all the way down .. I am contemplating a twin 300 re-power. I am thinking of going to 30'' shaft motors. I NEED SOME THOUGHTS AND FEEDBACK ON THIS PLEASE ...

when I loosen the nut holding the prop, the whole shaft spins .... Is the key inside the hull or between the shaft and the prop?

My 2007 Marlin has a side power bow thruster that runs but does not turn the propeller.. Does anyone know what model Grady would have installed in this boat ? It is in a tunnel at the bow and has a single propeller. I tried getting the 3/4 lock nut off the propeller shaft but it just spins...

my marlin has an Isotherm cruise 49 .... it measures 15 '' wide about 20 inch high and about 18 '' deep ... 1.75 CF. not sure if the same .... Isotherm makes a cruise 42 which is smaller ... they are on the pricey side way over priced

screen name = ttles714 ====first name= tony===== 2007 Marlin300====twin Yamaha 2007 F250

Has anyone replaced the original Isotherm cruise 49 with a larger refrigerator ?? (2007 Marlin)

question .... did you install the Marinco panto arms /blades on the original motors on your Marlin ??? picture or video ? Not sure but I think my 2007 Marlin has a different (larger) windshield. ????

If I recall correctly.... years ago, my 2001 Marlin .. I went thru the same situation .... After about half dozen times of dealing with the Groco , I was done with it !!! What idiot ever thought that set up was a good idea ??? My recollection is that top of the tank had one or two...

do you have any idea what model stereos it will work on ?? how many pins in the connector ?

want to buy

I didn't buy A ladder.. I was trying to do a repair .... I needed the extra work of the repair because I did something stupid last fall !!! One of those things !!! I just finished the repair .. Of all the choices, I chose to drill a 1&1/2 inch hole on the vertical just opposite the bolt...

I am going to get a borescope inspection camera to get a better idea of "what and where",.. Then Grady White lived up to their excellent customer service record and responded to my issue ...I am going to attach their recommendation, which included a detailed picture by picture of the...

thanks ... I would love to see them ... do you know where they are ?? I have crawled into the bilge as far as i can go ... there is no way i can reach the bolts, ... in fact i can only see ( about 3 feet away) the 2 outboard mounting bolts and i can see the tow eye bolts ... there is an...

I need to get at the boarding ladder mounting bolts on 2007 Marlin ( the inboard bolts) .... It looks as though my only options are sending a 3 year old kid inside the bracket with a wrench !!! LOL or Drilling and installing an access deck plate or something along those lines. Has anyone...

My 2001 Marlin with 250 hp OX66's with aux charging cables had a much better system then my 2007 Marlin with F250's... Both with 4 batteries but the older had much better isolation between house and engine batteries ... The OX66's actually had an isolation system built into the engines. So...