Search results

  1. C

    Seacock Remote Operation Arm

    interesting i thought it would have been straight threads as the thru hull fitting looks like it's straight.
  2. C

    Seacock Remote Operation Arm

  3. C

    Seacock Remote Operation Arm

    Do you have a part number on the Groco valve? I need to replace the one for the generator I removed. Thanks
  4. C

    Sailfish 282 Deck Drain Hose Cutting Access Hole

    Good advise. You have to get your hand in there to pull off the old hose and push on the new one. I put the 2 hose clamps on slid back a bit then heated the ends and pushed on from the interior to the discharge hull side first then connected to the new deck scupper. Did the outboard one first...
  5. C

    Rear Seat Base

    Looking to identify the material the rear fold up seat base. It's some sort of 1/2" thick plastic. It's not starboard (lighter). Thanks
  6. C

    Starboard Cockpit Replacement Drain question for my 2006 360 Express.

    I had already removed my rusted out generator. The hatch gave me access to the hose clamps. I used the fabricated tool to reach thru from the generator side to pull off the old hoses. i attached the hose clamps loosely to the end of the hose and tightened them by reaching thru the new access.
  7. C

    Starboard Cockpit Replacement Drain question for my 2006 360 Express.

    yes.
  8. C

    Exhaust inspection

    I had one done on my pre purchase. They used a scope so no disassembly other the the prop required. also had them hook up a Yamaha diagnostic to get rpm run times report. It also revealed a discrepancy between what the gauges said the hours were on one of the motors vs what the ECM had recoded...
  9. C

    Starboard Cockpit Replacement Drain question for my 2006 360 Express.

    I added a a 6" pry out hatch on the vertical surface that the door swings into to get to the hose clamps on the hull side drain. It is a 330. the other thing I had to fab up was a J shape pick tool on a long handle so I could pull the old hose off.
  10. C

    Loop Around South Florida

    Thanks for sharing your trip. Never even thought of having the boat moved to a starting point then traveling back home. Brilliant
  11. C

    - Wire Tracing for a 330 Hard Top

    spot on. found the offending corroded plug behind the bolster and round access.
  12. C

    - Wire Tracing for a 330 Hard Top

    Thanks, Heading over this weekend to sort it out.
  13. C

    - Wire Tracing for a 330 Hard Top

    I'm chasing down a bad - ground wire from my hard top. Any ideas what -busbar it runs to from the Hard Top? I pulled the electrical panel and cleaned the - busbar behind the panel no joy. Is there a ground connection on the Accessories fuse panel? (hard to see where they put that thing) if I...
  14. C

    Rigging tube length for 330 Express

    My 02 has similar length rigging tubes.
  15. C

    Backup bilge pump discussion in January

    Nice. I Added a high water alarm at the suggestion of my surveyor. I think its a requirement on new boat builds with overnight capability.
View older results