Search results

I use a electric contact spray cleaner from NAPA and a brass wire brush for the parts I can get to, and the spray and pipe cleaner for the small nooks and cranny that look like they need to be cleaned. Then sometimes I use a dielectric grease , the same stuff i use on all my boating electronics...

Re: Re-Attaching Rubber(?) Lining of Cabin Window on Adventu low heat and even heat over a large part of the rubber is the way i did mine when it popped out.On the sharp corner make sure the rubber is hooked under the point. A heat gun might be to hot, on high use a lower setting.

Before you get a new pump, put the old one out an power it on a good battery, I saw some of your other post and pictures and blade fuses get dirt and fail , it bite me before and i learned from it. And all wire connection need to be clean. Maybe try cleaning all the connection, and what I do now...

http://www.seaviewglobal.com/en/products/396 I got a duel mount for radar and camera with the wing for the gps and tv antenna, will that look stupid on a smaller boat. does anyone have this setup ?

I trick i do is put the soap of your choice in the bilge add water, pull the bilge pumps fuses and drive around on the trailer mixing it up drive splashes it all over in all the places you can't get to. then go back put a large tank under the bilge out pipes and put the fuses back in and let...

You could put it on a timer. Set it for what you think per day.

I got 50 1/2 between them od 54 1/2. outside

the two oil tanks are one per motor, fill both at the same time, might be 2 gallons half way will take a gallon. I never had a working fuel gauge,I use the fuel ,management system it will tell you pretty close to used gallons, and it a safer way to watch your gallon per hour and end of day useage.

good stuff I have some on board

Going down into the cabin there is a round o ring port in the floor, there should also be 4 screw with about a 12 inch by 20 inch floor panel. If you pop open the round port hole with a coin, there is a small box just aft of the port hole .There’s a float switch and pump in the small box. I...

use a hair dryer to heat the rubber then just put it back in, do not use a heat gun too hot

pictures, My feeling are never use insurance unless it's major loss. I have a spare cowling for older Yamaha 200, or any v6 I think is the same, is it the top only? Or maybe see if the people that covered it haves insurance, seems there works was the reason for your loss.

That's a year newer than my boat, 15,000 would be a great price, and if the motors are in good shape a steal. you can't get hurt very bad at that price. Pictures, trailer, electronic, hardtop, options, boating is not a cheap sport. I just spent 10 k on new stuff for my old boat and will never...

I have a older ICOM with a a 23 foot antenna, it needs a turner and takes a little time to install. It works well can talk all over , but I only listen and have it set to the emergency frequency , you have to take a USCG class on proper radio used and get a one time fcc license. The worst...

I'm not understanding what your asking? where are you mounting the speakers? Post a picture of where and what your doing, I have a 1994 sailfish and mounted my speakers up on the hardtop . was thinking of adding a few down in the round ports holes under the steps up the walk around area, but...

I'm working on a front fiberglass mold to close the front of my sailfish, Plan on making it 1/4 fg with two glass windows and wipers, just in the planing stag will post pictures and progress when it gets a little warmer up here in Maine, -8 out there right now, to cold to think about anything...

Nice boat good luck and welcome to the GW family.

This is where I had my boat done, give him a call and tell him what you want. http://www.redmanmarinefabricators.com/ ... /v/T-Tops/

Go big as you can.

does your house battery have a 1 and 2, I have on or off? what do you run on your house battery? I added a few solar panels on the hardtop to keep a little current input , when just sitting out offshore fishing.