Search results

Sent you a email...I'm interested.

:-| What sucks is that no one has the authority to clean all this spam up. Where is Seafarer228g? Time to step up and fix this or give someone else permission to do so!

Nice....I like the way the deck came out. You probably have quite a few hours into it. Are the thru hull fittings on your todo list, they look original.

found it. made by perko. here is the link if someone else needs it in the future http://www.westmarine.com/webapp/wcs/st ... sNum=50704

Does anyone have a P/N or info for the plastic latches that keep the motor well fold down door in place? I checked southco's website but no luck.

From what I have read the vst is 2 micron. I have a carb sws and am running a racor 2 micon main filter separator. I would recommend...draining the tanks completely, searching the internet on removal and cleaning of filters on your type of motor (that other forum does have alot of good info) I...

Assuming you have the bottom drain in the box....you could make a standpipe that fits into the drain port, drill holes in pipe so water can stay at a height you would want, yet drain. Then have a small pump for circulation. Manually fill the box with water as needed. You still need to run 12v...

Repairing the transom holes is not that difficult. I used Loctite marine epoxy, local lowes had it. I drilled the existing holes oversized, mixed the epoxy and used a syringe to fill the holes. Dries in 24hrs. I had to repeat application so that after sanding it was flush with the gel coat. Also...

I would put a access plate on the floor between the two fish box drains that way you can get to both if needed. Or just seal the broken drain flange and be done with it. I just went through replacing all the thru hulls and what a pita to do.

Sounds like you got a deal! Bet you it will run great when you get her in the water. Great to have another 20' on board.

On the left side of unit is a rubber stopper...remove said stopper, find small funnel and fill with atf.

Just curious, with all the things you have done, have you changed out the thru hull fittings? There have been issues with the plastic ones cracking.

A lot of times the screws are hidden behind the "buttons" . Use an awl to find them

ayacht..what is this epoxy and filler you speak of ? Is there is specific brand to use ? This is going to be on my todo list.

On my 95 the deck has a large access that is removable to get to the fuel tank. I've noticed on later models that the access is limited if not impossible for tank removal without cutting into deck. :(

Re: Repair shop blew engine on sea trial after "fixing it" w What I would do is...have my lawyer give them a call. You should not be responsible in my opinion.

Maybe this is close to what you are looking for ?... ATTWOOD 66553-1 STAINLESS STEEL 1 1/2 INCH SCUPPER Or...Perko, part number 377-B08-PLB bronze

I have canvas that snaps onto the windshield and covers the helm area completely, I use this all season. I'm sure that would be alot less cost. With my hardtop I use the full clear enclosure in spring and fall only. I don't know how much the hardtop adds to resale value either but I think you...

I'm one, count me in. I think it's the biggest 20' wa out there. Had a small cc prior, but had to pick my days for fishing on lake erie. Can't wait till spring! I don't post much, but always look forward to the 208 posts.

well... :dance . I don't see um