Search results

Any other pictures of the pod set up?

Found a old thread that should be helpful. I knew I'd seen a thread about this before. https://www.greatgrady.com/threads/cockpit-scuppers.28975/page-2

https://www.perko.com/catalog/underwater_hardware/441/thru-hull_scupper_for_use_with_hose/ Shows the 4 different versions, but no part number other than a 10 pack.

https://vancouver.craigslist.org/rds/trb/d/abbotsford-2007-karavan-ust-8000-tb/7346688272.html Older.

Ah, found the integrated flap perko. It also comes.in two lengths, it's just not obvious the way the description is. Now to find out if I need the 1 7/8" or 3" transom lengths. Have only found the bulk pack part number so far.

I was wondering if it might be thinner in the corner. I'm also hoping to get parts in hand before dismantling. Can be tricky to find things around here. Might have no choice. I should call Grady tommorow, they might have the answer.

My load range Cs carry 1820lbs each, that on my quad trailer. Load range Ds carry 2150, that's on my boat and travel trailer. The Es from Goodyear are a slightly bigger tire at 225/75/15 but are rated at 2830lbs!! I like the Es for our BC gravel roads, I've lost a lot of trailer tires...

I'm finally going to replace the plastic thru hulls for my rear deck drains....one is very suspect. I noticed that the bronze replacements don't have any means for attaching the rubber flappers on the outside. I'm not going plastic again(well maybe marelon) and they spend to much time in the...

Mine was 6800 lbs on the trailer at the island highway scale last summer. Quarter tank of fuel. Trailer GVW is 7980 Capacity 6480 Trailer weight is 1500lbs. So boat weighed 5300lbs, low on fuel with no gear, anchor chain or anything on board. My trailer is just right. Remember around hear if...

Mines in 3rd hole down on the outboard, top hole on the bracket. It made a big difference in performance!

I just mounted my new 17 pitch 3 blade Yamaha on my 1997 seafarer, f225. Excited to try it as the boat came with a a 15 pitch Yamaha 3 blade. With the 15 I could easily pass 6000rpm. Cruising at 30mph would be just over 5000 rpm... I've moved my motor up twice and each time was game changing...

1997 seafarer, 2005 Yamaha 225 four stroke(420 hours), susuki kicker. same as the boat in the ad, just not quite as clean. I haven't got around to getting it detailed.

Seattle area, not mine. https://seattle.craigslist.org/see/boa/d/seattle-grady-white-seafarer228/7345476261.html Mine might get listed in September, but is in Canada, West coast.

If it's the same parts as the 9.9 Yamaha Make sure it's the updated part!! My dad went through the same thing and it died after two uses and more than 30 days. To update the parts you replace the motor and hydraulic system. After a long battle with Yamaha they hooked him up with all the updated...

If you dont like it...let me know!

Ill get it in line...lol

Theres a difference between affording them...and mortaging them.

Guilty, but nothing wrong with watching dream boats go by. Learned a lot of what not to do. A bit of what to do.

My downrigger wires are fused and run direct from a bus bar at the batteries. Grounded directly to batteries. I wouldn't run them off a distribution block in the console, sounds like that's where your getting power?

Watch out,my 228 might hit the market after summer so I can upgrade. Located on Bowen Island, not far from you...