Search results

Yes I am my boat is in Somers Point. Great bunch of people

I would be interested also. I’m in Somers Point. Also have a friend in OC with a 33 express and another in Somers point with an overnighted

I have a 1998 Islander I can try to answer any questions you may have

I think because it’s easier and quicker and I’m sure more inexpensive. Once it wet it is a very costly repair.

I glassed the holes then put the brass fitting in so if water does get in the green board will not get wet.

I went through it two years ago. I ended up redoing the entire transom and glassing it completely closed. Make sure you address the brass through hulls in the motor well. I had water entering there also because one of the brass fitting had cracked. Youngs Fiberglass did my boat and I am...

Can you see it in this picture? If not I am picking my boat up this week I can send you a better picture.

My 1998 268 was ordered with just the main tank 134 gallon tank. The tank is also located in the forward compartment. When I pulled my hatch up the fill hose and vent hose are already run and capped off and the wires for the fuel gauge are also there. I also want to add the Aux tank for the...

They are reversed on the Grady white site for my 1998 Islander.

That’s what I’m looking to do before I pull the boat. Starting in December fishing the outer banks for giants.

skunkboat you asking about the sea bass?

Clams and squid. We were moving all over the deep water reef. Most of the bigger fish where off to the side of the wreck

When I was going mine transom I talk to Grady they recommend that I use wood the way the boat came from the factory. That way it would not change the way the boat sits in the water or the way it runs.

We went sea bass fishing Saturday. We left Harbor Cove at 7 am and had sixty keepers by noon fishing the deep water wreck. Great day

They are pretty much all the same. it came out great and i removed the bang strip that Grady put on and glassed it completely closed. Here are some pictures before the new motors went on.

Here is the cut on my 1998 Islander 268. It was cut on the outside.

Here are some pictures of my transom when it was apart.

We fished the deep water reef Friday. It was a 28 mile run from the inlet. Limited out on sea bass as wind Continued to pick up. Was going to head to a set of pots about ten miles away the changed our mind and headed home to clean fish and give the boat a good cleaning for all rain we are going...

Martek did my Garmin setup and very happy GREAT JOB and good people

Fished the 30 line and trolled up two nice yellowfin. Bite shut down then did some chunking three unreal run offs that broke the leader. Not a bad day at all. Hoping to head out this weekend.