Search results

Welcome. This is a great site. You will like it

Looks very nice. Water looks flat too

1990 Seafarer. The hard plastic seat base that the cushions attach to are stained. Does anyone know how to clean them up? I have tried everything I can think of . It seems like the stain is set in the plastic. Thank for any input.

Thanks hookup. I understand what you’re saying now that you explained it to me. I guess I’ll use the 5200 since I have it. It makes sense now. I don’t think I’ll be taking it off for as long as I live . Thanks again

well i finally got it off. It was loaded with 5200. KI had to lift and slice with a fillet knife. But it came off I won't be using 5200. I really can't see the reason for it Thanks for your imput. G

I did think it may be 5200, because it is absolutely murder trying to get it off. I’m going to try it again today Thanks G

That's exactly what I did. I removed the 4 bolts and the one that has the cleat attached to the 3/4" bolt that goes into the anchor locker. It must be held down by all of gthe caulk. I'm going to attack it again tomorrow. Thanks for your imput. I wanted to see if I was missing something. G

Need some help here. Trying to remove the pulpit off of my 1990 Seafarer. everything has been removed and it doesn't want to budge. Could it be all of teh caulk under it? I cannot figure what is holding it. Any help[ would be GREATLY appreciated. Thanks

Hey Thank you . I will try that

Hi everyone. Looking for buddy boat running out of Barnegat inlet N.J. Not saying I want to be at your side , but someone I could follow a little once in a while to sorta get the lay of the land , or sea . I have 226 Seafarer , 225 single Honda . Garmin Fantom Radar and two MFD displays. Any...

Donated yesterday. This site is great!

Just made a donation to the Great Grady site. Great place for information and great people to talk to . thanks to everyone for all of your help.

I saw a new Grady in Anchor Marina in northeast Maryland. Really nice boat , had a s.s. Cap on the transom. It was polished to a mirror finish

I would be happy to donate , but I won’t use a credit card. How else can I donate?

Good luck to you

I measured 44 1/2. I don’t know where you are but it’s frieking cold here. West Chester pa. Hope this helps

Hi . If I’m understanding you correctly, you want the measurement between the live well and the bait box next to where the batteries are. I have a 1990 226 seafarer. I don’t know if that would be different than a 228 , but I can check tomorrow. I have to take the cover off the back to get in...

Hi halfhitch, where did you get the non skid pattern mold? thank you.

I used a 3m eraser wheel and it worked great . I had tried everything else, but I’m impatient and couldn’t do peeling 1/4 inch pieces off. I thought the eraser wheel was much faster . I did both sides in about 2 hours . Cleaned it with acetone, then compounded it .

Thanks everyone for the valuable information. Now my head is really spinning. All I have to do is pull the trigger