Search results

  1. enfish

    Missing plastic fitting?

    This is a guess, but does your cockpit deck drain into the splashwell? I'd start by checking to see where the hoses from your cockpit drains go. I'm not familiar enough with the 248 to know, but I do know there are boats that do drain the cockpit deck into the splashwell.
  2. enfish

    First day on the water w 208, cruise speed off ?

    Does your GPS read mph or knots? Your numbers are similar to mine if they are in knots, but slow if mph.
  3. enfish

    First day on the water w 208, cruise speed off ?

    The OP has the advantage of living in San Diego which is typically a low humidity place... especially the last few weeks, we've had a lot of 95 degree, 12% humidity, 20-25 knot wind days... If the transom hasn't been wet too long, it's not over a large area, and you drill enough holes, you can...
  4. enfish

    First day on the water w 208, cruise speed off ?

    I've got the 1995 version of the same hull with the same bait tank mounted in the same location. Even when that is fully filled, fuel tanks full, 10 gallon fresh water shower tank full, and 3 guys fishing on the back, we do not get water on the deck through the scuppers. Since you had water...
  5. enfish

    208 Adventure trim tab placement

    Mount as far outboard as possible. But before you start drilling holes, make sure you have clearance on the inside of the transom for the hydraulic fittings.
  6. enfish

    Adventurer 208 gas tank volume shortage

    Tomolalla, For what it's worth, I made some measurements today on my tank. Maybe they will be useful for you. It's 7 inches from the top of the tank to the deck at the forward inspection port for the fill hoses and just under 5 inches from the top of the tank to the deck at the aft inspection...
  7. enfish

    Prop question

    Congrats on the purchase! I have the same hull, same motor. I think my prop is 15.5/17 or 15/17.
  8. enfish

    Fuel Meter Help

    Do you have the Yamaha fuel management system? If so, it will only show gallons used, not remaining. You'll have to top off your tanks and do the math.
  9. enfish

    Adventurer 208 gas tank volume shortage

    It's been a while since I've had the inspection ports off, but if memory serves me correct, the tank is not flat on top. There is actually a raised area where the fill and vent lines come in to the tank. But I can't really recall. I was at the boat yesterday and now not again until next week...
  10. enfish

    Gas Tank Capacity Problem

    Should be the other way around, no? Stern down, bow up since the fill tube and vent are at the bow end of the tank.
  11. enfish

    Gas Tank Capacity Problem

    Assuming you're filling while on the trailer? How does your boat sit when connected to your tow vehicle? Since you're manually measuring the fuel level through the sending unit hole (I think?) at the aft end of the tank, and the fill tube is at the front of the tank, if the front of the tank is...
  12. enfish

    Grady 208 thru hull tranny position 1kW

    My only experience with a thru-hull transducer is one the previous owner installed. It was as far aft and as far outboard to the starboard side away from the keel as possible with access to it from the bilge (just forward and outboard from the livewell thru-hull pickup). Most of the time it...
  13. enfish

    New Grady White 208 owner with few winch/hardware qn's

    Congrats on the new boat and welcome to the board! My 2 cents... run that 175 until it dies. With ours, the sweet spot is 4000-4200 RPM's where we can get 2.8 mpg on nice water, but the fuel economy curve is fairly flat from 3600 to 4400 RPM's. Guys posting numbers with 4-strokes are getting...
  14. enfish

    ICOM 504 reception issues

    So did you do the automated radio check using the 504? If so, I'd guess the antenna is at least in decent shape since you were able to transmit. If you can transmit, you should be able to receive. If you turn the squelch down do you get static? I'm wondering if the speaker may have just crapped out?
  15. enfish

    Bad Rectifier?

    Reading 13 volts on a new, fresh charged battery isn't out of the norm. Each cell can hold up to 2.2 volts per cell (6 cells total, for 13.2 volts). But typically the battery won't hold that charge for too long and drop down to 12.6 volts (2.1 volts per cell). 14 volts with the motor running is...
  16. enfish

    Constant radio power 208 adventure

    Are you talking about a stereo or a VHF radio? Stereo's will lose presets without battery, VHF's should not...
  17. enfish

    Question on 1994 208 Adventure

    x2 on what Smoky said. The F150 is right at the minimum power for that boat, slightly under-powered for my tastes, so going stainless and possibly 4-blade should help. Your prop shop should allow you to sea trial a few different props to see what works the best.
  18. enfish

    Cat Urine on Cushion Covers

    I've had the cat using the bimini as a bed problem. The solution to that was to put a fender underneath the bimini so that it's suspended above the cabin. Had feral cat issues in the past dragging rabbits, squirrels, and whatever else they caught to eat on deck under the cover... Had rats get...
  19. enfish

    Offshore Pro 240 Project

    Link works for me with pics. Good work so far. I think she'll look great when completed!
  20. enfish

    Show me your custom baitwell

    I've never had that problem. From what I recall, the underside of the boxes are not gelcoated but there are no exposed fibers. Occasionally I'll take a spray bottle of bleach water and spray around inside there (and in the bilges), mainly to take care of any mildew.