Search results

If you are in a marina they are not going to be happy with you fueling from cans. Check your rules. Same gas. Major brands of gas have the same additives equivalent to techron/ring free Many marine fuel docks are 89 octane which is part of the reason they are so expensive. There is no need...

usually grady has a plastic knob for that. Its just a faucet valve. There is no solenoid. If the knob is not tightly closed the washer leaks.

don't use AF33 on the LU. It has copper. Use an outboard spray that has zinc.

If its like every other boat, There are 6" pie plates at each end of each tank. The sending unit is under the rear (toward stern) pie plate of each tank along with the fuel pickup hoses The fuel Fill/vent hoses are under the fwd pie plates. There is a label on top of each tank with its...

Some of the newer, expensive Hard bottom paints have no copper and can be pulled and relaunched. I think Vivid is one of them.

Just spend more time on your buddy's big boat....

Home Depot has a section of the hardware aisle full of rolls of weather stripping and "marine" gasket. Also plenty of styles of rubber feet(bumpers)

thats probably not original. just a cheap latch. There many types out there on Amazon or marine stores. There are better type latches for heavy lids. This is similar

Some parts research... This is a good deal!!!

The new style FS30 Galv Isolator is much bigger than original and won't mount to bottom of gunnel in same place. And, I need to move the original in any case so I can mount a rodholder(fishing is the highest priority!) So either I move it somewhere or just disconnect and don't use AC. The...

there's something fishy about SMITH1. Very ChatGPT like...

I am considering updating the shorepower on my 265x. 30A Receptacle, inlet breaker and Galvanic Isolator are all original. New spec is an ELCI 30A breaker and a Fail-Safe galvanic Isolator(Promariner FS30). I never had a water heater and I removed the microwave (and the DC refrigerator) for the...

As someone who has replaced a transom in the past and probably didn't need to.... First, wood looks pretty damn good to me.. I'm guessing he's going to dig out the wood left in the 4" edge and tuck the new pieces in. There is no reason to rebuild the tab pockets unless you want to spend an...

If the 330 has the flat mounting areas, that saves you from using the fairings but you still need two transducers if you are not mounted on the keel. this explains it.

most anchor lockers drain to the bilge. It is typical grady to drill the holes in bulkheads and stringers after glassing, leaving core exposed. That won't be the only spot.... Not sure but I think they only keep the anchor locker separate from the bilge and put a drain when they have an anchor...

Never seen that before but if they are there, they are below the water line and you need a good hose.

The electronics in boats get added/replaced at different times and that second pic is not unusual. You can be OCD about how it looks but remember... as soon as you tie them all together nice & neat, you will have some reason to pull one out...

The picture is a 265 express not a 330. The inlets have no adverse effect on the GT51. I haven't looked under the generator on a 330. I'm surprised there is a "stringer" on the centerline. Maybe just a bulkhead for the generator platform? You can't offset it without using a fairing to keep...

https://www.greatgrady.com/threads/deck-drain-scupper-surprise.28979/

behind the two drawer unit in the cabin. puts it right under the captain's feet. away from pumps. Don't put ferrous items (tools) in the drawers. read thru this https://www.greatgrady.com/threads/autopilot-upgrade-from-manual-hydraulic.26808/ Its Garmin but you'll get some ideas about...