Search results

Dennis, you're proposing a reverse flush. I like the simplicity of it, will the flush get through whatever pump is in the middle?

I have been winterizing my boat the last few days, and now need to address the AC/Heat system. Unfortunately, I am clueless on how to do this. I believe this is a self-contained system, and water is drawn in through a seacock. But how do I flush it out, or circulate antifreeze through it...

I accessed the macerator through the mid berth hatch. You only need to remove the two mounting screws on the bow side of the mounting bracket. the stern slide slips under the screws that hold the other "thing" that is on top of the holding tank. Attached are a couple of pics to show you what...

I replaced the macerator pump on my 2008 Sailfish earlier this year. The macerator sits on top of the holding tank. It's a bit of a reach to get the mounting screws and hoses, but doable. Luckily I have long arms. The pump is readily availble at boat stores. I also had to replace the hand...

Don't know amything about this boat, other than it looks very nice! Also looks a bit overpriced. I bought a 2008 282 Sailfish in April 2022, with Yamaha 250s with 650 hours and well equipped electronics, for $85K. For one year newer and one more foot of length, not sure its worth the extra...

You had a big day. Hope it alll went well!

That looks like a great day on a flat ocean, a rarity! What year is your Sailfish? I have a 2008 282.

So I have a 2008 282 Sailfish that I bought this year. Love the boat, its been great and I feel VERY comfortable on it in the ocean. I bought the boat for fishing and some day trips or sandbars, and it is built for that! The cruising part, maybe not so much. I noticed you only received one...

Impressive!

Thanks!

Skunk, those are some great fish! Can I ask you what type of lure or bait you were using? We had bunker all over the place off our beach (Barnegat Light) yeterday and today, along with dolphin and a whale further out (I could only see its spout). I tried surf casting with poppers, yo-zuri...

Took my volt meter to the boat to test the circuit. Initially the wiper did not work. But after jamming my test leads into the connectors a few times, viola, the wiper started to work! Can't say I fixed anything, but it does show the wiper motor is OK. We'll see how long it continues to...

I was at the Garden State North reef yesterday and was on top of all sorts of black sea bass. Caught 6 keepers and probably tossed back another 12 shorts. Also caught two small blue fish and one tiny fluke, which were tossed back as well. Good to be out on the ocean again after the last week...

Legend, that's my next step. Any idea which of the wires to use when I connect the volt meter? I could just try every combination. Seasick, the rocker switch does not change the wiper speed. Lower position turns on both port and starboard wipers. Upper position turns on Starboard only.

How do I find out if the problem with my wiper is the switch or the wiper motor? The port windshield wiper has stopped working on my 2008 282 Sailfish. It was working fine a couple of months agao. Then, ove the last month it started working only intermittantly. Then it started to only work...

I bought replacement blades for my 2008 282 Sailfish earlier this summer from West Marine. These are the complete arm, not just the rubber blade. They worked well for about a month. But now the driver's side blade gaps in the middle and does not clear the spray off the entire windshield...

I found the Performance Data from Yamaha for a 282 Sailfish with twin four stroke 250s. Looks like you were right, I should be able to run at 4000 RPM which is about 31 MPH and get 1.85 MPG. Of course these numbers are obtained in "optimum conditions", which I assume mean a smooth body of...

This is going to take a full tank of gas and a week or two to figure out. Thanks for your advice and I'll get back to you once I have more data. In the mean time, good fishing!

I have Raymarine electronics and just found the "page" where it shows distance travelled and fuel usage. However, I have to wait for my next fueling to reset the page so it can calculate MPG. I can get up to 30 MPH, probably around 4800 RPM, but the fuel consumption starts climbing fast as...

Skunk, that's a nce trip! I was at the North Ridge on Friday for a few hours and caught one spanish mackerel. Tracked my gas usage and it looks like I'm getting 1.5mpg when crusing at 3600 - 3800 rpm, which is about 21knots.