Search results

Good choice. Not worth getting a snapped spring while going down the road.

Those pads are screw on and made by 3m. The compound, polish, and wax is a combo that cuts work in half and it lasts a lot longer than other products. Been using that combo for 20 years. Nothing but “wow” from my customers.

Ty. Apply all products with applicator pad

My 88 was very chalked up and oxidized when I bought it quick 3 step process, and it shines like new.

Compound uses a white compound pad with slow rpms. Aqua buff uses a yellow polish pad high rpms and wax is wiped off with microfiber cloth.

Blood is right. Woody wax is great for quick touch ups and motor hoods. This is an amazing combination of compound, polish, then wax. Can read a newspaper in the shine of the hull. Did this for a customer in less than 1 hour.

I use oil eater cleaner and a scrub brush for non skid and soft brush for hull. . Then rewax the area. Will clean the gel Cote with no problem. Oil Eater Original 1 Gallon Cleaner/Degreaser https://www.amazon.com/dp/B000EALHHG/ref=cm_sw_r_cp_api_i_xkL.EbCF6E2F7

I think you would be able to angle one of these in without cutting the boat.

Is it a red rusty color?

Doesn’t look like you will get it in the locker. Cable may hit the wall. That little angle will get you.

Looks like motor removal to change cable. I would try some pb blaster. Work it in, then wipe off and apply grease. May need to take off the seal cap if it has one on end of tilt tube.

More pic

Another problem I had with my hard top was the cabin was leaking through the bolt holes of the bolts were wearing out the bolt holes from rough water. This is how I fixed the problem. I went with 3/8 in aluminum plate and 5/16 and 3/8 bolts for mounting. 5200 under the mounts. . Never had a...

More pics.

More pics

My offshore

A racor with a drain will drop all the ethanol and water in the bottom of the glass and you drain it as it comes out. No need to make a mess dumping or replacing filters. They filter better than any one on the market. B32013 is the Yamaha replacement size.

I can’t see any reason the engine would need to be moved. Post some pics when you get a chance n I’m sure it can be figured out.

If a new style wema will fit in there without cutting the boat, , cut the old sender out.

Did they remove the engine