Search results

Not sure if they have them but try McMaster? They usually have odd stuff.

I actually just purchased the attwoods on boatID for $32 each. Everywhere else was higher.

Model # 17075086 Springfield twin 46 flip up. I thought I took pictures and for whatever reason I can't find them in my phone. I'm going back to the marina and another week to hopefully pick up my boat from getting the yearly maintenance done. I'll snap some pics and put them up. If you have...

Italian angler, curious what size props are you running?

Yep ok, that's what thought. I searched and found the same part numbers, yet no one stocks them. I called perko and they said only a dealer can order them. Which is stupid. I ended up getting the full stainless from grady and haven't installed them yet because I'm still not comfortable putting...

Cam ena sue, which model scupper is the one in bronze you posted?

Just installed it. Couple of notes. It's much more supportive than the seat I replaced. If you are sitting on the side where bolster can flip up, it sorta makes you sit up right correctly. If you switch positions and sit opposite of the flip up boslter (fixed position), it's more roomy and...

I think you guys are correct, I just needed to make sure before the install. Last thing I wanted to do is have to change it all around after the fact. Thank you guys!

I currently have quantum radar sitting on top of 5-in pedestal. I know these pictures aren't the best but here's few from after I installed the quantum radar. And then here's another close-up of one from when I first bought the boat with the old radar. My fear is obviously that it will obstruct...

Did a quick search and couldn't find any pictures. Just wanted to see if anyone else has installed foot on their hardtop and how they approached it. Did you end up installing it upside down etc?

Im looking to do the exact same thing as you! It appears tho that the backrest/bolster portion below the side window is attached some how. I tried wiggling it today just to see if I could lift it up and off, but no luck.

I'm debating on raising my companion seat 5 inches and i know I need to remove the bolts from the storage compartment underneath. What I'm not sure of is how to remove the back/bolster that is attached to the port side? Has anyone done this?

Thank you skunkboat! It seams as tho the previous owner did some splicing as stated. I going to boat in the next day or so after I get the replacement push/switch and map out the wiring from the inside. You posting what you have above at least verifies I'm not going crazy. Can't thank you enough.

Off topic question, is that white square cover above your keys a si-tex auto pilot? I only ask because I have one and am clueless after 3 years how to operate it.

Ok so I just ordered this and hoping it's as comfy as it looks. The measurements online don't seem any wider than. The stock chair I have. I'll follow up after the order comes in.

I think that's what I'll do. I took the advice above and already put everything back together, with the exception of the courtesy/dome, before I find a problem that isn't there . I think tomorrow I'm going to take the light apart and look into it more. I do know that the light worked perfectly...

This is the way it was before I disconnected it was: Blue wire-connected to another blue wire that exists electronic box Grey- went to fuse block 10amp Red-went fuse block 15amp Red again, which I find out to really be black at the source- went to ground block Not sure if this matters but in...

I have a 2001 282. The wires I'm referring to are in regards to the dome courtesy/ spreader light combo..... That combo light that is attached to underneath the electronics box. It's a dual switch one controls the spreader lights and one controls the actual dome light. There's nothing in the...

Hey skunkboat trust me I take this all as good advice. I know it's hard through typing and messaging but I'm taking this all in as a positive. And I'm more than appreciative for any and all input. okay I put everything back together with the exception of the dome/spreader wires. The reason I...