Search results

I’m still holding out hope the price comes down.

VCR's were also 1000 bucks... microwaves very expensive too when first introduced. They got dirt cheap as time went on so maybe there's hope for us average boaters.

Very accurate... the ratio of money spent vs confidence doesn't add up motor vehicle cold air intake: few hundred at most and you can find dozens of people who have put the same on your same exact vehicle- Low buy in and a pretty accurate idea of what you will get for the money even if you...

I'd much rather go for the newer boat Personally, I'm not the best captain on the earth but even a dope like me doesn't see the need for helm master. That 330 will have a bow thruster and the engines on a 330 are very far apart. A little practice can make up for that. Seakeeper is whole...

There's lots of products we buy for our boats that we will never get the money back out of...As a group, we boat owners just piss away money. If normal folks knew the real truth, most would say we were insane. And don't even get me started if our wives actually found out the truth. I'm among...

I volunteer to be the first V8 verado powered 330 express to run sharrow props. Sharrow can PM me for the address to send my free props to! If they get 15% better speed at 4500 rpm I'll even pay full retail! lol

I've also seen the tests. where do they show how these test boats were optimized with conventional props before they were tested against sharrow? I'd love to give them a try but I'd hate to get banged for 10K and find out they are 5% better lol

I do the same. I disconnect the hose as close to the seecock as possible then blow it out with air.

Haulover and Boca are for sissies …. Colombia bar is for men!

1350. Have a relative with a west marine employee acct. very big discount. They MSRP for over 1800

Thats how I roll now... but still looking to mount my search light as a backup Nightwave Install

same here... my canal has some BS ligthts at the end but you can't see them till you are about 10 feet away. they are solar powered and prob cheap. I had a remote light on hardtop but took it off to put the radar there. thinking about relocating that to the pulpit

I bet a spare ecu would solve that issue. Swap the factory one back if you need service.

Relocated MFD

If you are going with yamaha, then get the 250's and flash them as the other guy suggested... of course try it out first and you may find you don't need it. I was torn on the gauges. In the end I bought a newer 12" simrad and had them link it with the mercury engines. I like having all that...

I also have an '04. I also need to do my fresh water sensor as it does not work lol. On transducers, you could have anything at this point. Even if you have all OE ducers and MFD's, I don't believe grady rigged them with all the same stuff. As far as I could tell, mine came new with the stand...

I agree with this-but it can be a self fulfilling prophesy. not ever cycling it can lead to it not sealing the one time you do try it. If you have one that you don't know the history on or if your'e sure it's never been cycled- then yes I agree don't touch it if you can avoid it. better yet...

That's a lot of issues for a piece of equipment that rarely fails. these things go for years and years with only minor issues. time to peel back the onion and figure out what's really happening. crusties setting up shop in the thruster tunnel? you replaced "everything" what does that mean...

Since the 30 Marlin hasn't changed much in 20 years, there are a lot to choose from. Don't be afraid of an older hull that's been repowered-as long as it surveys ok . Early 2000's that got repowered 4/5 years ago will probably the best bang for your buck as they have some hours and the...

I'd start with checking the engine mounting height. Antiventilation plates should be right on the water surface while at planing speed. I found the easiest way to figure it out is to take a 15/20 second video and then screen shot it. Trying to stay still and actually snap a pic is nearly...