Search results

On my 330 I have the radar on the Seaview mount on the hump and a search light in the front about 12 inches behind the leading edge of the hard top. It all works good. Not sure an additional wedge is required in your case. The beam width of the new Garmin’s is pretty wide and mine works fine...

You didn’t mention that you checked the fuel water separator. It could be something as simple as water in the fuel and you may not have noticed it when changing the VST components. I always pour my fuel water separators into a glass jar and look for clear and bright fuel with no water layer.

Ditto

If not underway and the bottom of your cowling for the engine itself is in the water, you have a problem! If you were talking about the midsection which is below the engine then you may be OK.

New Wire Marine, pricey but outstanding quality.

On my 2007 330 the hose in the port side sink is accessible from an access panel in the rear cabin overhead. I changed mine, but don't remember if I had to remove more than one panel . Very easy actually.

If you want to know the exact color of the OEM canvas call AJ Canvas in Vanceboro NC and ask Lee. She has information on the exact color Sunbrella they put on them. I needed to match my 2007 beige color and she told me which Sunbrella they used. Mine I believe was silver but she’ll know what the...

Warranty?

Some are of the opinion that transmitting sonar when out of the water can damage the transducer. Placing the DSM300 on a separate switch would allow sonar to be easily turned off, saving battery power and keeping the transducer cool out of the water. There could also be load sharing issues...

On my 2007 330 I replaced Garmin 5212s with slightly different sized 1243xsv MFDs. Ordered custom bezels from NewWire marine. Plug and play with a little cutting of existing holes. Existing holes were too small in horizontal dimension and too large in vertical dimension. Very easy! No need to...

Differential GPS or DGPS requires a land-based surveyed site transmitting to your receiver. If you are truly using the DGPS then you need to have that specific transmitter dialed in near you. If you are referring to WAAS, that is a different enhancement and doesn’t require a specific land based...

I believe that is a 6y5-8350F-80 type gauge. Found the install manual on line at manualslib.com. One manual covers numerous legacy gauges including wiring diagrams

Get the manual for the gauge and make sure the programming is correct. The sender is programmable based on US or European and there are other programmable options for your gauges. Might want to check those before you go into detail troubleshooting.

I went out and tapped my 330 express. It is solid to slightly above the waterline maybe all the way up to the scupper through hulls which are several inches above the water line. My waterline appears to be about 3 inches below where the tapping sounds become more hollow.

Not a Coast Guard requirement on recreational vessels.

Agree with Hookup1, buy the parts and do your own not that hard.

Below the waterline is solid fiberglass. if you open some panels you can see where the cored sides begin well above the waterline.

Seems you would want to finish the gelcoat before you hang the motors. Just my two cents!

You need to measure the distance between the clamps that hold the blade on the underside of the arm.

My 2007 330 has blades that require the Narrow (0.25”) refills. I found that Anco N-22R is a bit long maybe 2 inches but works fine. They are very cheap online. mine appear to be identical to the ones pictured above. The need is for a quarter inch wide refill that slides in and locks on one end...