Search results

The Sea Sense 2 7/8" white plastic and rubber scupper ones fit perfectly. Got em on Amazon.

I'd change any plastic ones (if you have them on the motor end) but would leave the other until I had an issue. Just my 2 pennies.

I'm sure it can be done in the helm area, but to be honest I think that isn't rational on several levels. The best for an enclosed area is a small AC unit. You can either box one in or if there is space behind a wall you might fit it in. You'll need airflow and return space. I'd probably be...

Sure, you can do it but it will help slightly and will probably look like .... and not stand the test of time. The seal is and how many times you are in and out of it are the biggest factors. The spray insulation is relatively thin as well. I'd also use block ice vs crushed ice. I use water...

yea, it's a Bowmar as stated and a standard size. Measure the inside and outside frame and go to WM with pics and measurements. They can match it up for you.

You'd think there would have been a serious improvement project in this area, but just like the transom seams - nope.

IDK if this really requires a precise measurement requirement. The aft fishbox cover is at the same height as the gunnel height. I have a Magma table that is about 8 inches higher than the gunnel. I've had kids to adults filet fish and in 25 years of boating on a 282 and a 300 nobody has ever...

I really like Nautical One mildew remover.

Bldg 21 did work for several GW dealers in the past. I've used them as well. Quality work.

if access issues persist, maybe shoot an email to GW cust service and ask them to measure?

In addition to a dehumidifier, you can use a small resistive heater/air dryer (Westmarine sells one) with fan would help. Some starbright moisture packets work well too.

https://www.greatgrady.com/threads/chase-273-hydraulic-steering-hose-help-needed.38759/#post-276600 May help.

I'd check the battery switches.

Motor would be a big focus area. I'd agree to get a tech to look at the boat. If it cranks, get her going and see how she runs in a barrel or with muffs. If you do the deal, get all the maintenance stuff done over several years done. Have the tech go through it fully and change whatever else...

Spray insulation on sides and bottom. Maybe 1.5" thick. Access to add more may be problematic and most likely the top is where the greatest loss is. I would test first and see how it performs. Likely best to have a RTIC, YETTI or other large cooler.

I think that it's a tad underpowered. You can put that package on a 30' hull today.

They mostly drain into the bilge is my experience.

The boat really has not changed much at all over the years. - (2) rod holders on the bow LHS of the cabin. Newer have (4) (2) on both sides. Prob 7' spinners max can fit there. - (6) mid birth rod holders. Best for heavier shorter boat rods. Ideal for 5' 6" or so. Will fit larger but it is...

^^ I did this to replace the stock charger.

For a small AC trickle charger I had a CTEK conditioner. Small unit but it lasted only a year. Just tried a small Battery Tender model after a recommendation from a guy at work will see how it lasts.