Search results

As said look at the frame or other side. Probably 1/4". Glass guy I spoke to and canvas companies have been using acrylic instead of polycarbonate. Acrylic won't yellow as fast from UV damage. Acrylic can be heat formed as well. But its not as "bulletproof".

Did you drop any pitch when you changed? Some guys won't do it because they think they will loose top end. If props loaded wrong it can be significant improvement. Ken ran my numbers and recommended 4-blade props, 2" less pitch and slightly smaller diameter. Complete game changer. Boat as a 10...

Go with #4 to be safe.

Have you tried 4-blade props? Worked for mine.

Cutting the pickup is a really "bad" half-arsed "solution". I told you it would be difficult to get all the crud/water out. Running the boat gets it in suspension and its gets picked up by the filters. You can't wait until the engine stalls. You have to be prepared to stop, dump the filter and...

Chris - I have a Harbor Freight version of that tool. OK for smaller terminals up to about #6 splice. The cable cutter types work better on lugs. I'm pretty good at soldering but the big stuff is difficult to so. Get a good crimp tool...

ProMariner was terrible before. Glass fuses. Back on charger after a days fishing you grab fuse holder and they were uncomfortably hot. When cold they weren't working. Fuse came out in pieces. Chop it off and switch to blade type. The new ProMatiner which I have is great. I still recommend...

Mine are plastic. Not sure they have ever been replaced.

How old are the batteries? May be time to replace. What group/sizes are they. 4 batteries - look to see which ones are in parallel. Battery charger cables may have inline fuses at the battery. My ProMariner does. If this is blown you won't charge. Get your voltmeter out. Batteries off charger...

Melnor hose quick connects from ACE Hardware or online. Same parts only lees expensive.

Make up a y-hose for flushing - one side to rabbit ears and the other to the flush port. Snake out the tell-tale back into fuel cooler with 300 lb mono or string trimmer plastic.

Look at the Owners Manual for the wire list. Look for the high amperage connections possibly with inline fuse. You have a newer model than my boat but it should be similar. These power wires will come out of the rigging tubes and connect to battery terminal or switches. There is a circuit...

On my islander there are two power feeds from batteries to the helm/electronics box/overhead. The breakers/fuses are sized for short circuit protection of the wire runs and the device. The devices don't really draw that much power. You can use the red/white hardtop power to power all your...

Use search...lots of discussion on this topic. Search results for query: courtesy light

Let's get some competition going... Threaded plastic ferrule to tie throttle/shift cable together(old and new) to pull thru conduit. Holesaw hack to drill a smaller hole out larger.

It will break off. Talk to a welder. Replace it if he can't repair it.

On my Vetus bow thruster it is behind the prop in the lower unit. This is where it should be on all bow thrusters. Pulling the motor must be a pain.

What model SidePower thruster do you have? SidePower does not have a shear pin on the back side of the propeller. Instead it is under the electric motor and drives the lower unit.

Looking at your boat layout and where the conduit tubes are there are places where cable are going to be ties to the boat. For example the electrical panel in in the middle of the boat and forward of the conduit tubes. You are really going to need to open panels up and investigate. Understand...

So this appears to be an AI response to a GG post "Where is the ground?". Arish12: Where is the Ground? is a powerful question that resonates on multiple levels—both literal and metaphorical. On one hand, it may refer to a search for stability, a place to land, or a foundation to stand on. On...