Search results

Many posts on this. Port side may be doable with batteries removed, starboard side, nearly impossible without cutting. could remove the diesel tank and get to it with long arms, but much less work to cut and put a cover plate on the starboard side. There are numerous posts on this.

It’s probably fine. That is a tapered, brass fitting (NPT). It will not completely seat, if it was me, I would remove it, clean the threads put some thread compound on it and tighten it back in to snug with a wrench or maybe 20 foot pounds. Some say Fingertight plus a couple turns if it doesn’t...

I'd be interested in what you find. I could not see any on my 2007 330 either. Port side has them fore and aft

Try Southco.com for hinges, They supply GW

1.0 to 1.1 at 4300-4400 RPM 26-27 Kts with 3/4 fuel, full water, 4 pob. 2007 with 2022 F300s

Typically mounted under the foredeck near the windlass. Hard to see unless you stick your head in the anchor rode locker.

I think we’ve all done it once. I now remember it! Sorry you had to go through all of that to remind us all.

Do your gauges light up when you turn the key on? Also, I assume your Kill switch system has been isolated and is not the problem. The other switch that will cause this is your neutral switch if your shifter is not in neutral there’s a switch on the engine that will not allow it to turn over...

What makes you think it is ignition related? How do you know the "ignition is dead?" That is less likely than something else. That engine is quite reliable and ignition is typically not the problem. But, easy to check spark at the plugs. I'd look at fuel also, drain the VST into a clear jar...

When I installed my new Canvas, I let it hang for 2 to 3 days, then pulled it tight by hand marking where the snaps would go. It now stays nice and tight regardless of the outside air temperature and has been that way for three or four years now. Of course, the longer it is in the vertical...

Depending on your temperature, let your Canvas hang for a day or two before you install the snaps. It will stretch out and the Canvas will be loose if you do it too early.

I’d get the Ydis software and cable to troubleshoot. Not expensive. Look for TPS (throttle position sensor) setting/voltage. If this started all at once or over time, look at rigging as well. The YDIS can tell you a lot and test several components. Not likely to be a major issue on both engines...

Just search on MD auto and Marine weather seal. Available at Amazon or Home Depot comes in two sizes. I have found uses for each size on my 330.

When you install them, plan on letting them hang on the boat for a day or two in warm weather before placing the lower attachment hardware. In the past, A&J did not install the bottom fasteners when shipped. Be ready to fit the bottom snaps, etc. They lent me the tool to do it back several...

Mine is behind the electrics switch panel in the cabin. Easy access to electronics box from there and rigging tubes aft.

You are correct and it is probably safe. If your insurance company doesn’t have an issue, I don’t think the engines are gonna fall off or sink the boat unless of course the transom is bad. And like you say if the transom is bad, it’s bad! If you are going forward with this, recommend you look at...

The 2006 (and 2007 330 express hull that I have), is rated for a maximum of 600 hp according to the specifications in the owners manual. That manual is available online at the Grady-White website. I re-powered my boat with 300s and have been very pleased with the increased performance as opposed...

To be accurate, if using a magnetic compass,(wet compass) you need to develop a compass deviation card. It will tell you the difference between your compass reading and actual magnetic heading at the various quadrants. The GPS does not provide heading. It provides course over ground. Not that...

I recommend you don’t think of battery banks as powering anything. I think of it as the starboard battery switch powering the house items and the starboard motor. The port switch powers, the port engine and sometimes auxiliary items such as your winless or bow thruster. Each switch has the...

If you have your battery charger for your handheld, I believe you can plug it in and get power to the handheld even with a dead battery. Depends on I guess the status of the battery though.