Search results

That’s what I’m looking to do before I pull the boat. Starting in December fishing the outer banks for giants.

skunkboat you asking about the sea bass?

Clams and squid. We were moving all over the deep water reef. Most of the bigger fish where off to the side of the wreck

When I was going mine transom I talk to Grady they recommend that I use wood the way the boat came from the factory. That way it would not change the way the boat sits in the water or the way it runs.

We went sea bass fishing Saturday. We left Harbor Cove at 7 am and had sixty keepers by noon fishing the deep water wreck. Great day

They are pretty much all the same. it came out great and i removed the bang strip that Grady put on and glassed it completely closed. Here are some pictures before the new motors went on.

Here is the cut on my 1998 Islander 268. It was cut on the outside.

Here are some pictures of my transom when it was apart.

We fished the deep water reef Friday. It was a 28 mile run from the inlet. Limited out on sea bass as wind Continued to pick up. Was going to head to a set of pots about ten miles away the changed our mind and headed home to clean fish and give the boat a good cleaning for all rain we are going...

Martek did my Garmin setup and very happy GREAT JOB and good people

Fished the 30 line and trolled up two nice yellowfin. Bite shut down then did some chunking three unreal run offs that broke the leader. Not a bad day at all. Hoping to head out this weekend.

Boat looks good. I put F150’s on my 98 in June the boat runs great. I am getting 44mph wot.

This issue is not only with the Islander it is all of the Grady white boats. It is something that most boat owners don’t really pay attention to until it’s too late and water has already gotten in. My boat was done by Youngs Fiberglass in Marmora NJ and they do a lot of gradys. But keep in mind...

I will say that the 268 with twin 150’s is a perfect match. The boat tops out at 44 MPH with a full tank of fuel and three Guys on the boat. I ran it 50 miles offshore and average 1.9 mpg. The motors have Just under 30 hours and will Continue to improve as time goes on. It is also performs...

It did come out very well. Now I’m looking for a marlin. It just never ends.

I did the transom with the same material that Grady used to keep the boat balanced. You have to cut two holes in the deck to remove the rings on the back of the transom it was the only way to reach them. So instead of putting inspection places I had all that reglassed to look original. Then we...

I have a 98 Islander that i put a new transom in two years ago. I fixed all the issues where water was getting in including that aluminum bang strip and the brass through hulls in the motor well. My transom was soaked but because the of the wood Grady uses had no rot at all it was all...

They are very easy to replace. I replaced two of mine in about a half hour. You can also have that one refurbished.

Glass it closed you never have to worry about it again.

Where is your Islander located. I have a couple of questions for you about The auxiliary tank.