Search results

  1. jmoneilthe2

    Gauge Identification

    I bought a 87 Seafarer where I am fixing everything up but I'm confused with one of the gauges. One says Water, the other Temperature. I'm sure the one that says Temperature is the engine temp, but the other says water and the dial only goes to 35. It has a small hose that goes to the engine...
  2. jmoneilthe2

    Help Identify this switch

    I am preparing to rewire the console on this 87 GW Seafarer. Next to the 4 toggle switch panel is a single toggle switch that I have no idea what it controls. Does anyone have an idea? Thanks.
  3. jmoneilthe2

    Bilge Pump on GW 1987 Seafarer 22

    Before I try to access my bilge pump, I was hoping someone else has done this because it seems a bit radical. The way I see it, you have to take the Live Well out to get under to the bottom of the boat where the pump is. Has anyone done this? Thanks.
  4. jmoneilthe2

    Electrical Bus Bar for a 1992 Seafarer

    I was looking for some information on my Seafarer's Bus Bar, particularly the amperage rating. It only has 9 fuse connections and I'm looking for a replacement that has 12, but I'm not sure about the amp rating. I found one with a rating of 20, but I'm not sure it that is sufficient. Thanks for...
  5. jmoneilthe2

    Trim Tabs

    I just completed an install of Lenco's 12 x 12 Trim Tabs to my Seafarer 22. I'm not sure how much it would have cost to have them installed, but I'm glad I did it myself because it wasn't that difficult. Can't wait to test them out.
  6. jmoneilthe2

    1992 GW Seafarer 22 Trim Tab Instalation

    I was hoping someone has installed trim tabs on a GW Seafarer and could help me in the placement of the tabs. I have seen other installs where they say 3 to 4 inches from the edge of the boat, but these boats don't have the hull design as the GW. Thanks for any advise, John
  7. jmoneilthe2

    Ramp and Clamp

    I just finished up installing a Ramp N Clamp to my trailer, where I keep my 1992 Seafarer 22. I also installed steps so I can get on my boat's bow after putting it in the water. I will testing this out next week and was wondering if anyone else has used this Ram N Clamp on their boat. Cheers
  8. jmoneilthe2

    1992 Seafarer 22 Fuel Tank Replacement

    My Seafarer is a 1992 and is in great shape, but even though I have had no issues with the fuel tank, I plan on opening the floor up and inspecting, and or replacing the tank. I was wondering if anyone has replaced a fuel tank on one of these boats? Any suggestions would be appreciated.
  9. jmoneilthe2

    Richie HF-73

    My 1992 GW Seafarer has a Richie HF-73 Compass that lost all it's fluid. I'm repairing it with new fluid but the light stopped working. I have looked all over for a replacement, but can't find one. Does anyone know where I could get one or a similar one to use?
  10. jmoneilthe2

    Transom thru hole

    I was hoping someone could guide me to purchasing new thru holes for my transom that have a flap to keep water from coming in
  11. jmoneilthe2

    Bow Roller for a 1992 Seafarer 22

    I have been looking at bow rollers for my 1992 Seafarer 22 and was hoping someone out there may have installed one so they could give me an idea on what to get. I attached a photo of the bow with a tape measure showing how much room I have to work with. Thanks for any help...
  12. jmoneilthe2

    Adding a Pulpit and Windless to a Seafarer 22

    I have a GW Seafarer 22 "2 Pictures attached, boat and bow" that does not have a Windless Anchor System. I was hoping for some feedback on installing a Pulpit and Bow Rail as seen in the third photo I have attached "Seafarer 22 with windless". I have found pulpits for sale but I'm not sure of...
  13. jmoneilthe2

    Converting from Hydraulic Steering to Fly By Wire

    I recently purchased a 1992 GW Seafarer 22, which had the original hydraulic steering. The steering is can be difficult at times, very stiff. I was hoping that I could get some feedback on converting to Fly By Wire. I have seen several systems for sale and was wondering if it is a good move.
  14. jmoneilthe2

    Adding a Windless Anchor

    I have a 1992 Seafarer 22 that never had a Windless Anchor installed. I was hoping to get some input from anyone who has added one to a similar boat, anyone who has some advise. I'm not getting any younger and since moving from a bay boat to a Grady, the anchor is just getting bigger and bigger...
  15. jmoneilthe2

    Adding a fresh water wash down

    I have a 1992 Seafarer 22 that doesn't have a wash down tank. Do they make tanks I could add. There is a large empty space under the floor in front of my gas tank. I was thinking of adding one there.
  16. jmoneilthe2

    1992 Captain Chairs

    I have a 1992 GW Seafarer 22 with the original plastic seats. I want to upgrade but need advise when it comes to installing the new chairs. I don't want to add a bunch of new holes where it mounts to the boat. Any suggestions? Thanks for your input. John
  17. jmoneilthe2

    Fuel Tank Size

    I have a 1992 GW Seafarer 22 and am trying to find out the size of my tank without taking the floor out. Does anyone have any idea. I just has a new Suzuki 200 installed and need to program the gage for accurate calculation on fuel consumption. Thanks for you help.
  18. jmoneilthe2

    Electric boat trailer winch

    I am looking to purchase an electric winch on my 1992 GW Seafarer 22’s Venture trailer and hoping for some suggestions. Hopefully one that won’t break the bank. Thanks
  19. jmoneilthe2

    Trim Tabs for a boat that never had them

    I have a GW Seafarer 22 (1992). I want to install trim tabs and have seen several types on the market. I'm leaning toward the electric opposed to the hydraulic kind that don't require drilling holes completely thru the transom with the exception of the hole for the wires. I was hoping someone...
  20. jmoneilthe2

    1992 GW Seafarer Drain Plug

    I measured my drain plug and the whole is about 1/2 inch. I bought 1/2 inch but they are to big. Does any one have a boat like this and know what size drain plug to use. I know this sounds crazy but I'm not sure on how to measure the whole and which drain plug to buy. Thanks for any help!