Search results

  1. D

    GW 180 Sportsman/Fisherman Prop

    Hello All, can you tell me what props you're running with a Yamaha F150 and what WOT RPMs you're reaching with a Bimini top up. Thanks in advance.
  2. D

    RPM's dropping on starboard motor when trying to get on plan

    Re: RPM's dropping on starboard motor when trying to get on I'm experiencing the same symptoms, all the research I've done points to bad fuel, clogged VST filters/injectors and possibly high pressure fuel pump. I've pumped out all my old gas, changed fuel lines/fuel water separator filter...
  3. D

    Pumping gas out of a fuel tank

    Thanks, good to know for the future. Already pumped the gas out through the fuel line from the tank using a fuel pump.
  4. D

    Pumping gas out of a fuel tank

    Already ran the engine on a brand new portable fuel tank with fresh gas, the boat has new bottom paint with zero growth on the hull, the prop is brand new per Grady White specs.
  5. D

    Pumping gas out of a fuel tank

    You are correct, I meant to say Teflon tape. I have run the motor, it won't reach WOT. All the research I've done and speaking with the service manager at Yamaha points to a clogged VST filter or clogged injectors or both. There was a lot of debris in the tank, the attached picture shows what...
  6. D

    Pumping gas out of a fuel tank

    Thanks for your suggestions. Yes, I could put the boat on a trailer, but that would take half a day to do. Yes, I could remove the injectors myself and take them to a place to have them serviced but that would take 3 or 4 hours. Injectors are only ~$104 each, to me, it's not worth the trouble -...
  7. D

    Pumping gas out of a fuel tank

    The mechanic charges ~$130/hr to work on a boat in the water + travel time, it's cheaper to buy new injectors and clean the old ones later for backup use.
  8. D

    Pumping gas out of a fuel tank

    I'm more concerned with debris in the fuel system - I may have either a clogged VST filter or injectors which will be replaced this week. I also noticed the previous owner used silicone tape to seal the threads on a 3 way fuel valve which will be removed & replaced. Will be replacing the...
  9. D

    Pumping gas out of a fuel tank

    Thanks for your replies. I ended up buying a 75 GPH fuel pump (on sale at O'Reilly Auto Parts $45) and pumping the gas from the main tank line into twelve, 5 gallon gas cans (on sale at O'Reilly Auto Parts $3.47 each). Put an ad on Craigslist for "Free - 5 gallon gas tanks with gas" - had 10...
  10. D

    Pumping gas out of a fuel tank

    Recently purchased a 2006, 180 Sportsman. The gas in the tank is ethanol and has been setting in the tank for over a year. I'd like to pump it all out and flush the fuel lines. Has anybody attempted to run a hose through the fuel fill hose to pump gas out of a Grady White fuel tank? The reason...
  11. D

    In-hull transducer for 180 Sportsman/Fisherman

    Thanks for your reply Bob. I have a 180 Sportsman and was looking for guidance for that boat.
  12. D

    In-hull transducer for 180 Sportsman/Fisherman

    Has anyone installed an in-hull (shoot through hull) transducer with good results above 30 mph, if so, what brand did you use and where did you end up placing it? Thanks
  13. D

    Kicker motor for 180 Sportsman/Fisherman

    Just purchased a 2007 Grady White Sportsman with a 2008 Yamaha 9.9hp high-thrust kicker motor - was wondering what diameter/pitch propeller would be best suited for this boat. Also, what WOT RPMs should I be looking for? Thanks in advance for any recommendations.
  14. D

    Updated Member List

    1) DaveHNL 2) Dave 3) 2007 180 Sportsman 4) 2006 Yamaha F150, 2008 Yamaha 9.9