Search results

It doesn't matter if it's vinyl. the problem is with the hull to topside joint on the transom. Water can find its way in between the vinyl an the corner finishing caps.... thru screw holes etc.

I just had my Transom repaired the correct way by Glassing over where the bang plate is located, removed the Greenwood Ply and used Coosa board. greenwood was wet but not rotten. https://www.greatgrady.com/threads/2009-306-bimini-transom.37441/

Actually was repaired in Port St Lucie.... Tradition Area. Behind Bass Pro Shops "Treasure Coast Customs"

It was the original bang plate piece of garbage. Yes the water seeps in between the bang plate in between the laminate on top and on the corners. Over time salt builds under the bang plate and pushes it out. Very poor half assed design. BTW....Grady is not the only manufacturer that has these...

I'm very happy with the work. Took 9 days from start to finish. I am pissed at Grady with this poor design. Called Grady and of course out of warranty. I had a few fiberglass companies look at it. The transom was still strong before the repair. I knew there was water intrusion because of the...

Here are more pictures of the progress. Removed wet plywood. Replaced with coosa board. Laminate Fiberglass over the Transom and into the splash well. All sealed up with glass .

Back in November 2023, I was doing routine maintenance on the Yamaha 350s when I noticed "swelling" on the upper transom from the bang plate down 5 inches. I was worried that water had made it's way into the marine XL plywood. Well today my fears were confirmed that the plywood was saturated...

Hello everyone.... Has anyone installed a 12v outlet for a electric reel on a 2009 306 Bimini CC? I want to use it for my deep drop setup. What location and how is the wiring run from the batteries? I am guessing I need a outlet on both port and staboard gunnels?? Thanks, Mike

Thanks for all your inputs.... I did some homework and the Fuel senders are ABYC 33 to 240 ohms, so I set the speed fuel gauge to ABYC. Still having issues though. Did some troubleshooting and found the Auxiliary Tank sender is bad. The boat has the original Royce senders. I called Grady and...

Hello, I have a 2009 306 Bimini with Twin 350hp Yamaha 4 strokes. I have recently purchased this boat and I have a few questions. The questions are with the Yamaha Square Command Link "Speed Fuel Gauge" What Fuel sensor type should be picked?? The choices are: ABCY (US), Europe, or Yamaha...

Hello All, My first post and first Grady I recently purchased a 2009 306 Bimini. How is the rear bolster pad removed. This bolster pad is above the collapsible aft seat. Thanks Mike