Search results

You will need two guys, the way i did it was use plastic wedges as i cut (several toilet spacers work well, they are small and cheap at home depot) under the flange......cut the silicone/caulking very carefully with a sharp edge or knife being careful not to touch the gelcoat, also make sure you...

First thing checked everytime i get fuel, very good advice Sharkbait

Did they get any water out? You may have had non-ethanol fuel if it was that old and if treated properly could have still ran the motors.....fuel polishing is for diesel, when someone filters gasoline it is to remove dirt debris, and water/ethanol.

'Some' is the very important word......if you run the boat often and the water content stays below .05% you would be closer to correct than not........once 10% ethanol fuel begins to phase separate (the water will pull the 10% ethanol out of the fuel and take the octane rating down with...

No polishing services exist for gasoline that is effective, once phase separation happens, the fuel octane is greatly affected and the fuel is no longer good and actually can be harmful in its low octane state for the combustion chamber.

Just debris, i removed all of them.

Photos for reference if anyone needs to see below the box, removal was to replace a starboard pull out underwater light. AC lines are easy to remove and do not empty the cooler ac system thanks to sealed connections similar to a minisplit home unit. Removed the screws under the lid and carefully...

After sucking up water into my fuel separators and causing a no start during the beginning of the fishing season in New Jersey, i decided to drain the front tank to see how bad it was. For this i removed the fuel sending unit in the front tank and inserted a twenty five inch piece of straight...